Track editing

4.Use the dial and cursor [Q]/[W] keys to specify the copy-source track and V-take.

In "TR xx-yy," "xx" is the copy-source track number, and "yy" is the V-take number. Use the dial to select the track number (1 – 10), and use the cursor [Q]/[W] keys to select the V-take number (1 – 10).

If you turn the dial toward the right when track 10 is selected, the following screen will appear.

key, you can scrub-play the track and V-take you specified in step 4. For details on using scrub-playback, refer to p.31.

•The starting location can be specified only between the beginning of the song and the last-recorded location (i.e., within the recorded data).

7.When you have finished specifying the starting location, press the [ENTER] key.

A screen will appear in which you can specify the ending

location of the copy-source.

In this screen you can use the dial to specify two adjacent odd-numbered/even-numbered tracks (1/2, 3/4, 5/6, 7/8, 9/10) as the copy-source. In this case, the V-takes currently selected for the two selected tracks will automatically be selected as the copy-source.

5.Press the [ENTER] key.

A screen will appear in which you can specify the beginning of the copy-source.

6.Use the cursor [E]/[R] keys to move the blinking area in the display, and turn the dial to specify the location.

The location can be specified in one of the following two ways.

•Specifying the location numerically
8.Specify the ending location of the copy-source in the same way as in step 6.

At this time, you can press the PLAY[R] key to play back the region between the specified starting location and ending location. If there is no recorded data at the specified ending location, an "*" symbol will appear in the lower line of the screen.

9.When you have finished specifying the ending location, press the [ENTER] key.

A screen will appear in which you can specify the copy-

destination track (and V-take).

10.Specify the copy-destination track and V-take in the same way as in step 4.

A screen will appear in which you can specify the copy-

destination location.

[Recorder] Reference

Move the blinking area to one of the M (minutes) / S (seconds) / MS (millisecond) areas in the bottom of the display, and turn the dial to edit the value of each unit.

•Assigning a previously-specified mark location

Move the blinking area to the MARKER area in the upper right

of the display, and turn the dial to specify the mark number.

HINT

11.Specify the copy-destination location in the same way as in step 6, and press the [ENTER] key.

A screen will appear in which you can specify the number

of times (1 – 100) that the data will be copied.

•By pressing the [TIME BASE] key to switch to the Measure display, you can specify the location in measure/beat/clock units.

•By holding down STOP[P] and pressing the PLAY[R]

ZOOM MRS-1044

39