Basic operation of the track mixer

2.Press the INPUT 1 (or INPUT 2) [ON/OFF] key.

The input mixer will be selected for pan adjustments.

3.Turn the dial to edit the value of the PAN parameter.

The PAN parameter can be adjusted in a range of L100 (far

left) – 0 (center) – R100 (far right).

4.When you have finished adjusting the pan, press the [EXIT] key.

You will return to the main screen.

The function of the PAN parameter will change as follows, depending on the number of input jacks that are currently turned on, and on the number of recording tracks that are currently selected.

•When no recording track is selected

For the signal that is sent from the input mixer to the L/R channels of the [OUTPUT] jacks, the PAN parameter will adjust the pan (if either but not both INPUT 1 or 2 are enabled) or the balance (if both INPUT 1 and 2 are enabled).

•When two mono tracks or a stereo track isselected as the recording track

For the signal that is sent from the input mixer to the pair of odd-numbered/even-numbered tracks, the PAN parameter will adjust the pan (if either but not both INPUT 1 and 2 are enabled) or the balance (if both INPUT 1 and 2 are enabled).

•When one mono track is selected as therecording track

The PAN parameter will have no effect.

Basic operation of the track mixer

Adjusting the volume/pan/EQ

For each channel, you can adjust the volume, pan (stereo position between the L/R channels of the [OUTPUT] jack), and EQ (equalizer).

1.To adjust the volume (output level) of a channel, operate the fader of the corresponding channel (DRUM, BASS, 1 – 6, 7/8, 9/10).

HINT

•To check the precise setting of the volume (FADER

parameter), press the following sequence of keys: TRACK PARAMETER section [PAN] key → cursor [W] key → status key of the desired channel.

•You can check the MASTER fader setting by pressing any TRACK PARAMETER key → MASTER status key.

2.To adjust the pan of a channel, press the TRACK PARAMETER section [PAN] key, and then press one of the status keys (DRUM, BASS, 1 – 6, 7/8, 9/10) to select the desired channel.

A screen will appear in which you can adjust the PAN

parameter of the selected channel.

3.Turn the dial to adjust the value of the PAN parameter.

The range is L100 (far left) – 0 (center) – R100 (far right). If you want to continue and adjust the pan of another channel, repeat steps 2 – 3.

HINT

•For channels 7/8, 9/10, and DRUM, the PAN parameter is used to adjust the balance (the volume balance of the left and right channels).

•In the parameter screen you can also use the cursor [Q]/[W] keys to select parameters, and the cursor [E]/[R] keys to switch channels.

[Mixer] Reference

4.To adjust the EQ, press the [EQ HIGH] key or [EQ LOW] key.

Press the [EQ HIGH] key to adjust the high-range tone, or

the [EQ LOW] key to adjust the low-range tone.

ZOOM MRS-1044

49