Basic operation of the input mixer

● When a recording track has not been selected

HINT

INPUT 1

MASTER fader

or

INPUT 2

OUTPUT

 

L

Track mixer

R

INPUT 1

MASTER fader

INPUT 2

OUTPUT

L

Track mixer

R

NOTE

For details on selecting a send/return effect patch, refer to p.81.

2.Press the INPUT 1 (or INPUT 2) [ON/OFF] key.

The input mixer (INPUT) will be selected for operations.

HINT

The CHORUS/DELAY SEND parameter and REVERB SEND parameter are common to both INPUT 1/2 input signals.

3.Turn the dial to edit the value.

Increasing the value will deepen the effect. The range and default value of each parameter are as follows.

[Mixer] Reference

The diagrams above show the signal flow when the insert effect has not been inserted into the input mixer. For details on the signal flow when the insert effect is inserted, refer to p.77.

Adjusting the depth of the send/ return effects

The depth of the send/return effects can be adjusted by setting the volume (send level) of the signal that is sent from the input mixer to each send/return effect (chorus/delay, reverb).

In normal operation, sending the signal from the input mixer to the send/return effect will only apply the effect to the signal that is sent from the [OUTPUT] jacks, and will not affect the signal that is recorded on a track.

1.Press the TRACK PARAMETER section [CHORUS/ DELAY SEND] key or [REVERB SEND] key to select one of the send/return effects.

Press the [CHORUS/DELAY SEND] key to adjust the chorus/delay depth, or press the [REVERB SEND] key to adjust the reverb depth. The following illustration shows the screen that will appear when the [CHORUS/DELAY SEND] key is pressed.

•REVERB SEND : 0 – 100 (Default: 0)

•CHORUS/DELAY SEND : 0 – 100 (Default: 0)

HINT

•When the CHORUS/DELAY SEND parameter is displayed, pressing the [CHORUS/DELAY SEND] key will cause the signal sent from the input mixer to chorus/delay to be switched on/off. (The key will be dark when this is off.)

•In the same way, when the REVERB SEND parameter is displayed, pressing the [REVERB SEND] key will cause the signal sent from the input mixer to reverb to be switched on/off.

4.When you have finished making settings, press the [EXIT] key.

You will return to the main screen.

Adjusting the pan/balance

Here's how to adjust the pan (stereo position) of the signal sent from the input mixer to the [OUTPUT] jacks or recording tracks, or the balance (the volume balance between two channels).

1.Press the [PAN] key.

A screen will appear in which you can adjust the PAN parameter.

ParameterValue

48

ZOOM MRS-1044