Zoom MRS-1044 Press the [EDIT] key, 3.Press the [EDIT] key, effect module that you want to edit, 4. From the MODULE keys, press the key for the

				Using the insert effect
				4. From the MODULE keys, press the key for the
Effect	MODULATION/
module	DELAY			effect module that you want to edit.
Effect type				When editing a patch, use the MODULE keys to select the
	CHORUS	FLANGER	PHASER
				module for editing. The table below shows how the
Effect	DEPTH	DEPTH	POSITION
				MODULE keys correspond to the various effect modules.
	RATE	RATE	RATE
parameters	MIX	FB	COLOR

Here's how to edit the effect type and effect parameters for

the currently selected patch.

1.Press the [EFFECT] key to make the key light.

The display will indicate the currently selected patch.

2.Use the ALGORITHM keys to select an algorithm, and turn the dial to select the patch that you want to edit.

It is not possible to change the algorithm of the currently selected patch. For this reason, you must first begin by selecting a patch that uses the desired algorithm, even when you want to create a patch from scratch.

3.Press the [EDIT] key.

The upper part of the display will indicate "EDIT." This means that the patch may now be edited.

The following display is an example of when the [MODULATION/DELAY] key is pressed to select the MODULATION/DELAY effect module.

If you select an effect module using a key other than the [TOTAL] key, you can use the cursor [Q]/[W] keys to access the setting screens for the effect type and effect parameters of that module.

HINT

•The lit/dark condition of the [COMPRESSOR], [PRE AMP/DRIVE], [EQUALIZER], and [MODULATION/DELAY] keys indicates the on/off status of the corresponding module. (If you select an effect module that is off, the display will indicate "-OFF-.") Each time you press one of these keys, the setting will alternate on/off.

•To edit the ZNR or VOL PDL modules, press [TOTAL], and then use the cursor [Q]/[W] keys to display either "ZNR" or "VOL PDL." Then turn the dial to edit the parameter.

5. If you want to switch the effect type for the selected module, press the cursor [Q] key to make the display show "TYPE," and then turn the dial to select the desired effect type.

[MODULE key correspondence]

Key
Algorithm
GUITAR/BASS	COMP	PRE AMP/	EQ	MODULATION/	ZNR	VOL PDL	PAT LVL
		DRIVE		DELAY
SINGLE	COMP/LIM	MIC PRE+	EQ	MODULATION/	ZNR	VOL PDL	PAT LVL
		DE-ESSER		DELAY
MIC
DUAL	COMP/LIM	MIC PRE	EQ	DOUBLING	ZNR	VOL PDL	PAT LVL
LINE	COMP/LIM	ISOLATOR	EQ	MODULATION/	ZNR	VOL PDL	PAT LVL
MASTERING	3BAND COMP/	NORMALIZE	EQ	DIMENSION/	ZNR	VOL PDL	PAT LVL
	LO-FI			RESONANCE

[Effects] Reference

ZOOM MRS-1044

79