Troubleshooting

Troubleshooting

If the MRS-1044 does not function as you expect, check the following points first.

Problems during playback■No sound, or sound is very weak

•Check the connections to your audio system, and the volume of your audio system.

•Make sure that the status keys of each channel are lit green. If a key is dark, press the key to make it light green.

•Make sure that the fader of each channel and the MASTER fader are raised. If they are already raised, lower each fader and then raise it once again.

•If a scene with the volume lowered has been assigned to a mark, the volume will automatically be lowered when that mark is reached. Delete the scene that is assigned to the mark (→ p.52).

•The recorder will not operate when the [RHYTHM] key is lit. Press the [EXIT] key several times to make the [RHYTHM] key go dark.

■Operating the fader does not affect the volume

•On channels for which stereo link is turned on, the fader of the even-numbered channel will have no effect. Either turn stereo link off (→ p.50), or operate the fader of the odd-numbered channel.

■The display indicates "Don't Play" and playback is not possible

•The recorder will not operate in the current screen. Press the [EXIT] key several times to switch to the main screen.

hard disk (→ p.85).

•Recording is not possible if the project is write- protected. Either turn protect off (→ p.85), or use a different project.

■The signal from the [INPUT 1/2] (BALANCE) jack(s) is not input

•If plugs are inserted in the [INPUT 1] (GUITAR/BASS, UNBALANCE) jacks or the [INPUT 2] (UNBALANCE) jack, disconnect these plugs.

■The recorded sound is distorted

•Check whether the input sensitivity setting ([INPUT 1/2] control) and recording level setting ([REC LEVEL] control) were appropriate.

•Lower the fader so that the 0 (dB) dot of the level meter does not light.

•If the EQ gain of the track mixer is set extremely high, the sound may be audibly distorted even if the fader is lowered. Set the EQ to an appropriate value.

Problems with effects■Insert effect does not apply

•Make sure that the [BYPASS/TUNER] key is dark.

•Make sure that the insert effect is sent to the desired location (→p.76).

•Make sure that a MODULE key is lit. If all MODULE keys are dark, either press one or more MODULE keys to make them light, or select another patch.

Appendices

Problems during recording■The input signal cannot be heard, or is too soft

•Make sure that the INPUT 1/2 [ON/OFF] keys are lit.

•Make sure that the [INPUT 1]/[INPUT 2] controls are raised.

•Make sure that the [REC LEVEL] control is raised. If it is already raised, lower it and then raise it again.

■Send/return effect does not apply

•Make sure that the [CHORUS/DELAY] or [REVERB] key is lit. If it is dark, press the key several times to make it light.

•For each channel of the mixer, make sure that the REVERB SEND or CHORUS/DELAY SEND parameter is turned on. If it is on, make sure that the send level is raised (→ p.50).

■Can't record on a track

•Make sure that you have selected a recording track.

•Check whether you have run out of free space on the

96

ZOOM MRS-1044