Using the insert effect

Reference

Changing the insert location of the insert effect

When the project is in its initial state, the insert effect is sent into the input mixer. However, you may change the insert location as necessary. The procedure is as follows.

1.In the main screen, press the effect section [INPUT SOURCE] key.

The currently selected insert location will appear in the display.

Location at which the insert effect is inserted

The display has the following significance.

•INPUT: Input mixer (default setting)

•DRUM: DRUM channel of the track mixer

•BASS: BASS channel of the track mixer

•TR 1 – TR6: Channels 1 – 6 of the track mixer

•TR1/2, TR3/4, TR5/6, TR7/8, TR9/10: Channels 1/2, 3/4, 5/6, 7/8, or 9/10 of the track mixer

•MASTER: Immediately before the MASTER fader

2.Turn the dial to select the insert location.

HINT

While the above screen is displayed, you can also select the insert location by pressing an INPUT 1/2 [ON/OFF] key or a status key (DRUM, BASS, 1 – 6, 7/8, 9/10, MASTER). When using the status keys to select channels 1/2, 3/4, or 5/6 as a pair, press status keys 1/2, 3/4, or 5/6 simultaneously.

Applying the insert effect only to the monitor signal

Normally when the insert effect is placed into the input mixer, the signal processed by the effect will be recorded on the track. If necessary, however, you can apply the insert effect only to the monitor signal, and record the unprocessed input signal on the track. For example when recording the unprocessed sound of a vocal performance, the vocalist will be more comfortable singing if an insert effect suitable for mic recording is applied to the monitor signal.

INPUT

Insert effect

Recorder

1.Send the insert effect into the input mixer.

For the procedure, refer to the preceding section.

2.Press the [EFFECT] key, and then press one of the ALGORITHM keys that is already lit.

A screen will appear in which you can select an insert

effect patch.

3.Press the [PROJECT/UTILITY] key, and use the cursor [E]/[R] keys to make the display read

"UTILITY REC SRC."
[Effects]

3.Press the [EXIT] key.

You will return to the main screen.

HINT

If the [INPUT SOURCE] key is lit when you are in the main screen, this means that the insert effect is placed in a location other than in the input mixer.

4.Press the [ENTER] key.

A screen will appear in which you can select one of the following two types of signal to be recorded on the track.

•WET: The input signal that has passed through the insert effect will be recorded on the track (default setting).

•DRY: Only the unprocessed input signal will be recorded on the track. Even in this case, however, the insert effect will be applied to the monitor signal.

76

ZOOM MRS-1044