Prestige 2602HW Series User’s Guide

Figure 143 Menu 1 General Setup

Menu 1 - General Setup

System Name= ?

Location= location

Contact Person's Name=

Domain Name=

Edit Dynamic DNS= No

Route IP= Yes

Bridge= No

Press ENTER to Confirm or ESC to Cancel:

27.6 Internet Access Configuration

Menu 4 allows you to enter the Internet Access information in one screen. Menu 4 is actually a simplified setup for one of the remote nodes that you can access in menu 11. Before you configure your Prestige for Internet access, you need to collect your Internet account information.

Use the Internet Account Information table in the Quick Start Guide to record your. Note that if you are using PPPoA or PPPoE encapsulation, then the only ISP information you need is a login name and password. You only need to know the Ethernet Encapsulation Gateway IP address if you are using ENET ENCAP encapsulation.

From the main menu, type 4 to display Menu 4 - Internet Access Setup, as shown next.

Figure 144 Menu 4 Internet Access Setup

Menu 4 - Internet Access Setup

ISP's Name= MyISP

Encapsulation= RFC 1483

Multiplexing= LLC-based

VPI #= 8

VCI #= 35

ATM QoS Type= CBR

Peak Cell Rate (PCR)= 0

Sustain Cell Rate (SCR)= 0

Maximum Burst Size (MBS)= 0

My Login= N/A

My Password= N/A

ENET ENCAP Gateway= N/A

IP Address Assignment= Static

IP Address= 0.0.0.0

Network Address Translation= SUA Only

Address Mapping Set= N/A

Press ENTER to Confirm or ESC to Cancel:

The following table contains instructions on how to configure your Prestige for Internet access

292

Chapter 27 Internet Access