Prestige 2602HW Series User’s Guide

Table 100 Menu 11.3 Remote Node Network Layer Options (continued)

FIELD

DESCRIPTION

 

 

Address

When Full Feature is selected in the NAT field, configure address mapping sets in

Mapping Set

menu 15.1. Select one of the NAT server sets (2-10) in menu 15.2 (see Chapter 31

 

on page 313 for details) and type that number here.

 

When SUA Only is selected in the NAT field, the SMT uses NAT server set 1 in menu

 

15.2 (see Chapter 31 on page 313 for details).

Metric

The metric represents the cost of transmission for routing purposes. IP routing uses

 

hop count as the cost measurement, with a minimum of 1 for directly connected

 

networks. Type a number that approximates the cost for this link. The number need

 

not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good

 

number.

Private

This determines if the Prestige will include the route to this remote node in its RIP

 

broadcasts. If set to Yes, this route is kept private and not included in RIP broadcast.

 

If No, the route to this remote node will be propagated to other hosts through RIP

 

broadcasts.

RIP Direction

Press [SPACE BAR] and then [ENTER] to select the RIP Direction. Options are

 

Both, In Only, Out Only or None.

Version

Press [SPACE BAR] and then [ENTER] to select the RIP version. Options are RIP-1,

 

RIP-2B or RIP-2M.

Multicast

IGMP-v1sets IGMP to version 1, IGMP-v2sets IGMP to version 2 and None disables

 

IGMP.

IP Policies

You can apply up to four IP Policy sets (from 12) by typing in their numbers separated

 

by commas. Configure the filter sets in menu 25 first (see Chapter 40 on page 391)

 

and then apply them here.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm or ESC to Cancel:” to save your configuration, or press [ESC] at any time to cancel.

28.3.1 My WAN Addr Sample IP Addresses

The following figure uses sample IP addresses to help you understand the field of My WAN Addr in menu 11.3. Refer to the previous Figure 18 on page 79 in the web configurator chapter on LAN setup for a brief review of what a WAN IP is. My WAN Addr indicates the local Prestige WAN IP (172.16.0.1 in the following figure) while Rem IP Addr indicates the peer WAN IP (172.16.0.2 in the following figure).

300

Chapter 28 Remote Node Configuration