ZyXEL Communications 2602HW Series manual 394

Prestige 2602HW Series User’s Guide

Figure 247 Menu 25.1.1 IP Routing Policy

Menu 25.1.1 - IP Routing Policy

Policy Set Name= test
Active= No
Criteria:	= 0
IP Protocol		Packet length= 0
Type of Service= Don't Care
Precedence	= Don't Care	Len Comp= N/A
Source:		end= N/A
addr start= 0.0.0.0
port start= N/A		end= N/A
Destination:		end= N/A
addr start= 0.0.0.0
port start= N/A		end= N/A
Action= Matched	= 0.0.0.0	Log= No
Gateway addr
Type of Service= No Change
Precedence	= No Change

Press ENTER to Confirm or ESC to Cancel:

The following table describes the fields in this menu.

Table 131 Menu 25.1.1 IP Routing Policy

FIELD	DESCRIPTION
Policy Set Name	This is the policy set name assigned in Menu 25 – IP Routing Policy Setup.
Active	Press [SPACE BAR] and then [ENTER] to select Yes to activate or No to
	deactivate the policy. Inactive policies are displayed with a minus sign “-“ in SMT
	menu 25.
Criteria
IP Protocol	IP layer 4 protocol, for example, UDP, TCP, ICMP, etc.
Type of Service	Prioritize incoming network traffic by choosing from Don’t Care, Normal, Min
	Delay, Max Thruput, Min Cost or Max Reliable.
Precedence	Precedence value of the incoming packet. Press [SPACE BAR] and then
	[ENTER] to select a value from 0 to 7 or Don’t Care.
Packet Length	Type the length of incoming packets (in bytes). The operators in the Len Comp
	(next field) apply to packets of this length.
Len Comp	Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal,
	Less, Greater, Less or Equal or Greater or Equal.
Source:
addr start / end	Source IP address range from start to end.
port start / end	Source port number range from start to end; applicable only for TCP/UDP.
Destination:
addr start / end	Destination IP address range from start to end.
port start / end	Destination port number range from start to end; applicable only for TCP/UDP.
Action	Specifies whether action should be taken on criteria Matched or Not Matched.

394 Chapter 40 IP Policy Routing