Prestige 2602HW Series User’s Guide

.

Table 98 Menu 4 Internet Access Setup

FIELD

DESCRIPTION

 

 

ISP’s Name

Enter the name of your Internet Service Provider (ISP). This information is for

 

identification purposes only.

Encapsulation

Press [SPACE BAR] to select the method of encapsulation used by your ISP.

 

Choices are PPPoE, PPPoA, RFC 1483 or ENET ENCAP.

Multiplexing

Press [SPACE BAR] to select the method of multiplexing used by your ISP.

 

Choices are VC-based or LLC-based.

VPI #

Enter the Virtual Path Identifier (VPI) assigned to you.

 

 

VCI #

Enter the Virtual Channel Identifier (VCI) assigned to you.

 

 

ATM QoS Type

Press [SPACE BAR] and select CBR (Continuous Bit Rate) to specify fixed

 

(always-on) bandwidth. Select UBR (Unspecified Bit Rate) for applications that

 

are non-time sensitive, such as e-mail. Select VBR (Variable Bit Rate) for bursty

 

traffic and bandwidth sharing with other applications.

Peak Cell Rate

This is the maximum rate at which the sender can send cells. Type the PCR.

(PCR)

 

Sustain Cell Rate

Sustained Cell Rate is the mean cell rate of a bursty, on-off traffic source that can

(SCR)= 0

be sent at the peak rate, and a parameter for burst-traffic. Type the SCR; it must

 

be less than the PCR.

Maximum Burst

Refers to the maximum number of cells that can be sent at the peak rate. Type the

Size (MBS)= 0

MBS. The MBS must be less than 65535.

My Login

Configure the My Login and My Password fields for PPPoA and PPPoE

 

encapsulation only. Enter the login name that your ISP gives you. If you are using

 

PPPoE encapsulation, then this field must be of the form user@domain where

 

domain identifies your PPPoE service name.

My Password

Enter the password associated with the login name above.

 

 

ENET ENCAP

Enter the gateway IP address supplied by your ISP when you are using ENET

Gateway

ENCAP encapsulation.

Idle Timeout

This value specifies the number of idle seconds that elapse before the Prestige

 

automatically disconnects the PPPoE session.

IP Address

Press [SPACE BAR] to select Static or Dynamic address assignment.

Assignment

 

IP Address

Enter the IP address supplied by your ISP if applicable.

 

 

Network Address

Press [SPACE BAR] to select None, SUA Only or Full Feature. Please see

Translation

Chapter 31 on page 313 for more details on the SUA (Single User Account)

 

feature.

Address Mapping

Type the numbers of mapping sets (1-8) to use with NAT. See Chapter 31 on

Set

page 313 for details.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm or ESC to Cancel:” to save your configuration, or press [ESC] at any time to cancel.

If all your settings are correct your Prestige should connect automatically to the Internet. If the connection fails, note the error message that you receive on the screen and take the appropriate troubleshooting steps.

Chapter 27 Internet Access

293