Prestige 2602HW Series User’s Guide

Figure 6 Change Password at Login

7You should now see the SITE MAP screen.

Note: The Prestige automatically times out after five minutes of inactivity. Simply log back into the Prestige if this happens to you.

2.1.2 Resetting the Prestige

If you forget your password or cannot access the web configurator, you will need to use the RESET button at the back of the Prestige to reload the factory-default configuration file. This means that you will lose all configurations that you had previously and the password will be reset to “1234”.

2.1.2.1 Using The Reset Button

1Make sure the PWR/SYS LED is on (not blinking).

2Press the RESET button for ten seconds or until the PWR/SYS LED begins to blink and then release it. When the PWR/SYS LED begins to blink, the defaults have been restored and the Prestige restarts.

2.1.3Navigating the Prestige Web Configurator

The following summarizes how to navigate the web configurator from the SITE MAP screen. We use the Prestige 2602HW-61 web screens in this guide as an example. Screens vary slightly for different Prestige models.

•Click Wizard Setup to begin a series of screens to configure your Prestige for the first time.

•Click a link under Advanced Setup to configure advanced Prestige features.

•Click a link under Maintenance to see Prestige performance statistics, upload firmware and back up, restore or upload a configuration file.

•Click Site Map to go to the Site Map screen.

58

Chapter 2 Introducing the Web Configurator