Prestige 2602HW Series User’s Guide

Figure 162 Menu 4 Applying NAT for Internet Access

Menu 4 - Internet Access Setup

ISP's Name= MyISP

Encapsulation= RFC 1483

Multiplexing= LLC-based

VPI #= 8

VCI #= 35

ATM QoS Type= UBR

Peak Cell Rate (PCR)= 0

Sustain Cell Rate (SCR)= 0

Maximum Burst Size (MBS)= 0

My Login= N/A

My Password= N/A

ENET ENCAP Gateway= N/A

IP Address Assignment= Static

IP Address= 0.0.0.0

Network Address Translation= SUA Only

Address Mapping Set= N/A

Press ENTER to Confirm or ESC to Cancel:

The following figure shows how you apply NAT to the remote node in menu 11.1.

1Enter 11 from the main menu.

2When menu 11 appears, as shown in the following figure, type the number of the remote node that you want to configure.

3Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes and then press [ENTER] to bring up Menu 11.3 - Remote Node Network Layer Options.

Figure 163 Applying NAT in Menus 4 & 11.3

Menu 11.3 - Remote Node Network Layer Options

IP Options:

Bridge Options:

IP Address Assignment = Static

Ethernet Addr Timeout(min)= N/A

Rem IP Addr = 0.0.0.0

 

Rem Subnet Mask= 0.0.0.0

 

My WAN Addr= 0.0.0.0

 

NAT= SUA Only

 

Address Mapping Set= N/A

 

Metric= 2

 

Private= No

 

RIP Direction= Both

 

Version= RIP-2B

 

Multicast= None

 

IP Policies=

 

Enter here to CONFIRM or ESC to CANCEL:

The following table describes the options for Network Address Translation.

314

Chapter 31 Network Address Translation (NAT)