Prestige 2602HW Series User’s Guide

28.3 Remote Node Network Layer Options

For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network Layer Options as shown next.

1In menu 11.1, make sure IP is among the protocols in the Route field.

2Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press [ENTER] to display Menu 11.3 – Remote Node Network Layer Options.

Figure 147 Menu 11.3 Remote Node Network Layer Options

Menu 11.3 - Remote Node Network Layer Options

IP Options:

Bridge Options:

IP Address Assignment = Static

Ethernet Addr Timeout(min)= N/A

Rem IP Addr = 0.0.0.0

 

Rem Subnet Mask= 0.0.0.0

 

My WAN Addr= 0.0.0.0

 

NAT= SUA Only

 

Address Mapping Set= N/A

 

Metric= 2

 

Private= No

 

RIP Direction= None

 

Version= RIP-1

 

Multicast= None

 

IP Policies=

 

Enter here to CONFIRM or ESC to CANCEL:

The next table explains fields in Menu 11.3 – Remote Node Network Layer Options.

Table 100 Menu 11.3 Remote Node Network Layer Options

FIELD

DESCRIPTION

 

 

IP Address

Press [SPACE BAR] and then [ENTER] to select Dynamic if the remote node is using

Assignment

a dynamically assigned IP address or Static if it is using a static (fixed) IP address.

 

You will only be able to configure this in the ISP node (also the one you configure in

 

menu 4), all other nodes are set to Static.

Rem IP Addr

This is the IP address you entered in the previous menu.

 

 

Rem Subnet

Type the subnet mask assigned to the remote node.

Mask

 

My WAN Addr

Some implementations, especially UNIX derivatives, require separate IP network

 

numbers for the WAN and LAN links and each end to have a unique address within

 

the WAN network number. In that case, type the IP address assigned to the WAN port

 

of your Prestige.

 

NOTE: Refers to local Prestige address, not the remote router address.

 

 

NAT

Press [SPACE BAR] and then [ENTER] to select Full Feature if you have multiple

 

public WAN IP addresses for your Prestige.

 

Select SUA Only if you have just one public WAN IP address for your Prestige. The

 

SMT uses Address Mapping Set 255 (see Figure 165 on page 316).

 

Select None to disable NAT.

 

 

Chapter 28 Remote Node Configuration

299