ZyXEL Communications ES-2048 Table 42 MVR

ES-2048 User’s Guide

The following table describes the related labels in this screen.

Table 42 MVR

LABEL	DESCRIPTION
Active	Select this check box to enable MVR to allow one single multicast VLAN to be
	shared among different subscriber VLANs on the network.
Name	Enter a descriptive name (up to 32 printable ASCII characters) for identification
	purposes.
Multicast VLAN	Enter the VLAN ID (1 to 4094) of the multicast VLAN.
ID
802.1p Priority	Select a priority level (0-7) with which the switch replaces the priority in outgoing
	IGMP control packets (belonging to this multicast VLAN).
Mode	Specify the MVR mode on the switch. Choices are Dynamic and Compatible.
	Select Dynamic to send IGMP reports to all MVR source ports in the multicast
	VLAN.
	Select Compatible to set the switch not to send IGMP reports.
Port	This field displays the port number on the switch.
*	Settings in this row apply to all ports.
	Use this row only if you want to make some settings the same for all ports. Use this
	row first to set the common settings and then make adjustments on a port-by-port
	basis.

	Note: Changes in this row are copied to all the ports as soon as you
	make them.
Source Port	This field is applicable for Ethernet ports.
	Select this option to set this port as the MVR source port that sends and receives
	multicast traffic. All source ports must belong to a single multicast VLAN.
Receiver Port	Select this option to set this port as a receiver port that only receives multicast
	traffic. A receiver port cannot belong to a multicast VLAN.
None	Select this option to set the port not to participate in MVR. No MVR multicast traffic
	is sent or received on this port.
Tagging	Select this checkbox if you want the port to tag the VLAN ID in all outgoing frames
	transmitted.
Add	Click Add to save your changes to the switch’s run-time memory. The switch loses
	these changes if it is turned off or loses power, so use the Save link on the top
	navigation panel to save your changes to the non-volatile memory when you are
	done configuring.
Cancel	Click Cancel to reset the fields.
VLAN	This field displays the multicast VLAN ID.
Active	This field displays whether the multicast group is enabled or not.
Name	This field displays the descriptive name for this setting.
Mode	This field displays the MVR mode.
Source Port	This field displays the source port number(s).
Receiver Port	This field displays the receiver port number(s).
Delete	To delete a multicast VLAN(s), select the rule(s) that you want to remove in the
	Delete column, then click the Delete button.
Cancel	Click Cancel to clear the Delete check boxes.

154 Chapter 19 Multicast