ZyXEL Communications ES-2048 23.2 Load Factory Default, 23.3Save Configuration, Save, Save, Config, Config, Click Here, Maintenance, Configuration, Configuration, Load Factory Default

ES-2048 User’s Guide

Table 49	Maintenance (continued)
LABEL		DESCRIPTION
Save		Click Config 1 to save the current configuration settings to Configuration 1 on the
Configuration		switch.
		Click Config 2 to save the current configuration settings to Configuration 2 on the
		switch.
Reboot		Click Config 1 to reboot the system and load Configuration 1 on the switch.
System		Click Config 2 to reboot the system and load Configuration 2 on the switch.
		Note: Make sure to click the Save button in any screen to save your
		settings to the current configuration on the switch.

23.2 Load Factory Default

Follow the steps below to reset the switch back to the factory defaults.

1In the Maintenance screen, click the Click Here button next to Load Factory Default to clear all switch configuration information you configured and return to the factory defaults.

2Click OK to reset all switch configurations to the factory defaults.

Figure 76 Load Factory Default: Start

3In the web configurator, click the Save button to make the changes take effect. If you want to access the switch web configurator again, you may need to change the IP address of your computer to be in the same subnet as that of the default switch IP address (192.168.1.1).

23.3Save Configuration

Click Config 1 to save the current configuration settings permanently to Configuration 1 on the switch.

Click Config 2 to save the current configuration settings to Configuration 2 on the switch.

Alternatively, click Save on the top right-hand corner in any screen to save the configuration changes to the current configuration.

170 Chapter 23 Maintenance