|
| |
[metric <metric>] | = | The metric represents the “cost” of transmission for routing |
|
| purposes. IP routing uses hop count as the measurement of |
|
| cost, with a minimum of 1 for directly connected networks. |
|
| Enter a number that approximates the cost for this link. The |
|
| number need not be precise, but it must be between 1 and |
|
| 15. In practice, 2 or 3 is usually a good number. |
[name <name>] | = | Specifies a descriptive name (up to 32 printable ASCII |
|
| characters) for identification purposes. |
[inactive] | = | Deactivates a static route |
An example is shown next.
•Create a static route with the destination IP address of 172.21.1.104, subnet mask of 255.255.0.0 and the gateway IP address of 192.168.1.2.
•Assigns a metric value of 2 to the static route.
•Assigns the name “route1” to the static route.
sysname(config)# ip route 172.21.1.104 255.255.0.0 192.168.1.2 sysname(config)# ip route 172.21.1.104 255.255.0.0 192.168.1.2 metric 2 sysname(config)# ip route 172.21.1.104 255.255.0.0 192.168.1.2 name route1
33.7 Enabling MAC Filtering
You can create a filter to drop packets based on the MAC address of the source or the destination.
Syntax:
where |
|
|
name <name> | = | Names the filtering rule. |
mac | = | Specifies the MAC address you want to filter. |
Chapter 33 Configuration Mode Commands | 257 |