1Connect to the console port using a computer with terminal emulation software. See Section 3.1.1 on page 42 for details.
2Disconnect and reconnect the switch’s power to begin a session. When you reconnect the switch’s power, you will see the initial screen.
3When you see the message “Press any key to enter Debug Mode within 3 seconds ...” press any key to enter debug mode.
4Type atlc after the “Enter Debug Mode” message.
5Wait for the “Starting XMODEM upload” message before activating XMODEM upload on your terminal.
6This is an example Xmodem configuration upload using HyperTerminal. Click Transfer, then Send File to display the following screen.
Figure 18 Example Xmodem Upload
Type the configuration file's 
location, or click Browse to
search for it.
Choose the 1K Xmodem protocol.
Then click Send.
7After a configuration file upload, type atgo to restart the switch.
54 | Chapter 4 The Web Configurator |