Figure 19 Reload the Configuration file: Via Console Port
Bootbase Version: V0.6 03/06/2006 09:21:13
RAM:Size = 32 Mbytes
DRAM POST: Testing: 32768K OK
DRAM Test SUCCESS !
FLASH: Intel 32M
ZyNOS Version: 3.70(AID.0)b0 4/28/2006 17:27:36
Press any key to enter debug mode within 3 seconds.
.................................
Enter Debug Mode
Starting XMODEM upload (CRC mode)....
CCCCCCCCCCCCCCCC
Total 262144 bytes received. Erasing..
................................................................
OK
The switch is now reinitialized with a default configuration file including the default password of “1234”.
4.7.2 Reset to the Factory Defaults
To reset the switch back to the factory defaults, do the following:
1Connect to the console port using a computer with terminal emulation software. See the chapter on hardware connections for details.
2Disconnect and reconnect the switch's power to begin a session. When you reconnect the switch's power, you will see the initial screen.
3When you see the message "Press any key to enter Debug Mode within 3 seconds" press any key to enter debug mode.
4Type atbr after the "Enter Debug Mode" message.
Chapter 4 The Web Configurator | 55 |