Figure 12 Installed Transceiver
3.1.3.2 Transceiver Removal
Use the following steps to remove a mini GBIC transceiver (SFP module).
1Open the transceiver’s latch (latch styles vary).
Figure 13 Opening the Transceiver’s Latch Example
2Pull the transceiver out of the slot.
Figure 14 Transceiver Removal Example
3.1.4 Power Connector
Make sure you are using the correct power source as shown on the panel.
To connect the power to the switch, insert the female end of power cord to the power receptacle on the rear panel. Connect the other end of the supplied power cord to the power source. Make sure that no objects obstruct the airflow of the fans.
44 | Chapter 3 Hardware Overview |