Prestige 334 User’s Guide

CHAPTER 23

Remote Node Configuration

This chapter covers remote node configuration.

23.1 Introduction to Remote Node Setup

A remote node is required for placing calls to a remote gateway. A remote node represents both the remote gateway and the network behind it across a WAN connection. Note that when you use menu 4 to set up Internet access, you are actually configuring a remote node. The following describes how to configure Menu 11.1 Remote Node Profile, Menu 11.3 - Remote Node Network Layer Options, Menu 11.5 - Remote Node Filter and Menu 11.6 - Traffic Redirect Setup.

23.2 Remote Node Profile Setup

From the main menu, select menu option 11 to open Menu 11 Remote Node Profile (shown below).

The following explains how to configure the remote node profile menu.

23.2.1 Ethernet Encapsulation

There are two variations of menu 11 depending on whether you choose Ethernet Encapsulation or PPPoE Encapsulation. You must choose the Ethernet option when the WAN port is used as a regular Ethernet. The first menu 11.1 screen you see is for Ethernet encapsulation shown next.

Chapter 23 Remote Node Configuration

224