Prestige 334 User’s Guide
Figure 172 Menu 24.11 – Remote Management Control
Menu 24.11 - Remote Management Control |
| ||
TELNET Server: | Port = 23 | Access | = ALL |
| Secure Client IP = | 0.0.0.0 | |
FTP Server: | Port = 21 | Access | = ALL |
| Secure Client IP = | 0.0.0.0 | |
Web Server: | Port = 80 | Access | = ALL |
| Secure Client IP = | 0.0.0.0 | |
SNMP Service: | Port = 161 | Access | = LAN only |
| Secure Client IP = | 0.0.0.0 | |
DNS Service: | Port = 53 | Access | = LAN only |
| Secure Client IP = | 0.0.0.0 | |
| Press ENTER to Confirm | or ESC to Cancel: | |
The following table describes the fields in this screen.
Table 102 Menu 24.11 – Remote Management Control
FIELD | DESCRIPTION |
|
|
Telnet Server | Each of these |
FTP Server |
|
Web Server |
|
SNMP Service |
|
DNS Service |
|
|
|
Port | This field shows the port number for the service or protocol. You may change the |
| port number if needed, but you must use the same port number to access the |
| Prestige. |
Access | Select the access interface (if any) by pressing [SPACE BAR], then [ENTER] to |
| choose from: LAN only, WAN only, ALL or Disable. |
Secure Client IP | The default 0.0.0.0 allows any client to use this service or protocol to access the |
| Prestige. Enter an IP address to restrict access to a client with a matching IP |
| address. |
Once you have filled in this menu, press [ENTER] at the message "Press ENTER to Confirm or ESC to Cancel" to save your configuration, or press [ESC] to cancel.
32.1.1 Remote Management LimitationsRemote management over LAN or WAN will not work when:
1A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or Web service.
2You have disabled that service in menu 24.11.
307 | Chapter 32 Remote Management |