Prestige 334 User’s Guide

Figure 112 Menu 11.3 Applying NAT to the Remote Node

Menu 11.3 - Remote Node Network Layer Options

IP Address Assignment= Dynamic

IP Address= N/A

IP Subnet Mask= N/A

Gateway IP Addr= N/A

Network Address Translation= SUA Only

Metric= 1

Private= N/A

RIP Direction= None

Version= N/A

Multicast= None

Enter here to CONFIRM or ESC to CANCEL:

The following table describes the options for Network Address Translation.

Table 80 Applying NAT in Menus 4 & 11.3

FIELD

DESCRIPTION

 

 

NAT

Press [SPACE BAR] and then [ENTER] to select Full Feature if you have multiple

 

public WAN IP addresses for your Prestige. The SMT uses the address mapping set

 

that you configure and enter in the Address Mapping Set field (menu 15.1 - see

 

section ).

 

Select None to disable NAT.

 

 

 

When you select SUA Only, the SMT uses Address Mapping Set 255 (menu 15.1 - see

 

section ). Choose SUA Only if you have just one public WAN IP address for your

 

Prestige.

25.3 NAT Setup

Use the address mapping sets menus and submenus to create the mapping table used to assign global addresses to computers on the LAN. Set 255 is used for SUA. When you select Full Feature in menu 4 or 11.3, the SMT will use Set 1. When you select SUA Only, the SMT will use the pre-configured Set 255 (read only).

The server set is a list of LAN servers mapped to external ports. To use this set, a server rule must be set up inside the NAT address mapping set. Please see the section on port forwarding in the chapter on NAT web configurator screens for further information on these menus. To configure NAT, enter 15 from the main menu to bring up the following screen.

Chapter 25 Network Address Translation (NAT)

238