Prestige 334 User’s Guide
Table 105 Menu 27.1.1 IPSec Setup
FIELD | DESCRIPTION |
|
|
Content | When you select IP in the Local ID Type field, type the IP address of your computer or |
| leave the field blank to have the Prestige automatically use its own IP address. |
| When you select DNS in the Local ID Type field, type a domain name (up to 31 char- |
| acters) by which to identify this Prestige. |
| When you select |
| characters) by which to identify this Prestige. |
| The domain name or |
| identification purposes only and does not need to be a real domain name or |
| address. |
My IP Addr | Enter the IP address of your Prestige. The Prestige uses its current WAN IP address |
| (static or dynamic) in setting up the VPN tunnel if you leave this field as 0.0.0.0. |
| The VPN tunnel has to be rebuilt if this IP address changes. |
Peer ID type | Press [SPACE BAR] to choose IP, DNS, or |
| Select IP to identify the remote IPSec router by its IP address. |
| Select DNS to identify the remote IPSec router by a domain name. |
| Select |
Content | When you select IP in the Peer ID Type field, type the IP address of the computer with |
| which you will make the VPN connection or leave the field blank to have the Prestige |
| automatically use the address in the Secure Gateway Address field. |
| When you select DNS in the Peer ID Type field, type a domain name (up to 31 charac- |
| ters) by which to identify the remote IPSec router. |
| When you select |
| characters) by which to identify the remote IPSec router. |
| The domain name or |
| identification purposes only and does not need to be a real domain name or |
| address. The domain name also does not have to match the remote router’s IP |
| address or what you configure in the Secure Gateway Address field below. |
Secure | Type the IP address or the domain name (up to 31 characters) of the IPSec router with |
Gateway | which you’re making the VPN connection. |
Address | Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN IP address (the |
| |
| Key Management field must be set to IKE, see later). |
Protocol | Enter 1 for ICMP, 6 for TCP, 17 for UDP, etc. 0 is the default and signifies any protocol. |
Local | Local IP addresses must be static and correspond to the remote IPSec router’s config- |
| ured remote IP addresses. |
| Two active SAs cannot have the local and remote IP address(es) both the same. Two |
| active SAs can have the same local or remote IP address, but not both. You can |
| configure multiple SAs between the same local and remote IP addresses, as long as |
| only one is active at any time. |
Addr Type | This field displays SINGLE for a single IP address. |
Local IP Addr | Enter a static IP address on the LAN behind your Prestige. |
319 | Chapter 34 VPN/IPSec Setup |