Remington Operating Chain SAW, Turn chain tensioning screw Clockwise to tension saw chain

SAW CHAIN TENSION ADJUSTMENT

Continued

❸

		E
		T N
	G	H
T	I

Turn chain tensioning screw

clockwise to tension saw chain...

❹	Approx.
	Guide Bar

1/8"

Pullchaintochecktension.Guidelinks should not come out of guide bar groove...

❺

OPERATING CHAIN SAW

WARNING: Read and understand this ownerÕsmanualbeforeoperatingthissaw. Make certain you read and understand all Important Safety Information, pages 3 through 5. Improper use of this chain saw can cause severe injury or death from Þre, electricalshock,orbodycontactwithmov- ing chain, or falling wood.

FILLING OIL TANK

1.Remove oil cap.

2.Fill oil tank with SAE #30 motor oil. Note: For temperatures below 30¡F, use SAE #10 oil. For temperatures above 75¡F, use SAE #40 oil.

3.Replace oil cap at once. Tighten oil cap Þrmly for good seal. This will avoid oil seepage from tank.

4.Wipe off excess oil.

Note: It is normal for oil to seep when saw is not in use. Empty oil tank after each use to prevent seepage.

OILING CHAIN

Manual Oil System

Always check oil level before using saw. Do not at- tempt to operate the oil system while saw is in op- eration. To oil chain, press squeeze bulb. Oil will feed onto the guide bar and chain. Press squeeze bulb at least once before each cut. Check oil level often by looking at oil level through side of oil bottle (see Figure 9).

Oil Squeeze Bulb

ENGLISH

IG
T	H
	T
	E
	N

Oil Bottle

Make sure chain moves freely around guide bar then tighten nut.

Figure 9 - Oil Squeeze Bulb and Oil Bottle Location

Continued

113005 9 www.desatech.com