Schneider Electric LUFP7 user manual Using and Monitoring the TSX PBY 100 Coupler Configuration

4. Software Implementation of the Gateway

4.2.13. Using and Monitoring the TSX PBY 100 Coupler Configuration

After validating all the changes previously made, you may check the configuration of the TSX PBY 100 coupler, the Profibus-DP network, and the LUFP7 gateway by downloading the PL7 PRO application to the PLC and conducting a monitoring operation using the TSX PBY 100 coupler debug screen.

ÎTransfer the application from the PC to the PLC by running the “Transfer program…” option from the “PLC”

menu (or click on the button) and selecting “PC -> PLC”.

ÎSwitch from the OFFLINE to the ONLINE mode by running the “Connect” option from the “PLC” menu (or

click on the button).

ÎInitialize and start the PLC application using the “Init…” and “Run…” options from the “PLC” menu.

ÎOpen the “Hardware configuration”

and the	TSX PBY 100	board
configuration.	Then, switch	from

“Configuration” to “Debug” and select the line that corresponds to the LUFP7 gateway.

The content of the "PROFIBUS-DP diagnostic data” frame enables you to view the gateway's Profibus-DP diagnostics, while the “PROFIBUS- DP slave data” frame enables you to view and change the values of the gateway I/O. An example is given on the right.

4.2.14. Developing a Profibus-DP Application

The Profibus-DP master PLC taken as an example is a TSX 57353 v5.1, marketed by Telemecanique. A sample PLC application, developed under PL7 PRO, is presented in chapter 11 Appendix D: Sample Use under PL7 PRO, page 97. This example uses the PLC, the gateway and the 8 TeSys U motor starters shown in the Software Implementation of the Gateway.

37