Schneider Electric LUFP7 user manual Gateway Configuration Data, Bytes Name Description

12. Appendix E: Profibus-DP Data and Diagnostics

12.2. Gateway Configuration Data

These data are transmitted to the Profibus-DP master upon gateway initialization exchanges. These exchanges enable the Profibus-DP master to set up, configure, and diagnose each of the slaves. The TSX PBY 100 coupler conducts these setup exchanges, but they are not documented in its Implementation Manual. Please refer to the general documentation about the Profibus-DP standard if you want further information about initialization exchanges.

If you want to review the configuration data that have been exchanged during Profibus-DP slave setup, you may use the SEND_REQ function in an application developed using PL7 PRO. You must then use the 16#0031 command code and specifically request the reading of the configuration data for the slave concerned (see Implementation Manual of the TSX PBY 100 coupler).

The table below describes the structure and content of the response issued by the TSX PBY 100 coupler to a read command of the LUFP7 gateway configuration data:

Bytes	Name	Description
0-1	Total length	Total length of the configuration information, in bytes
2	Number of %IW	Total size of the input data in the %IW area
3	Number of %QW	Total size of the output data in the %QW area
4-5	%IW offset	Offset of the input data blocks in the %IW area
6-7	%QW offset	Offset of the output data blocks in the %QW area
8	Station Status	Configuration of the slave's services (see Profibus-DP standard)
9	Watchdog Factor 1	Slave timeout (see Profibus-DP standard):
10	Watchdog Factor 2	Timeout = (Watchdog Factor 1) × (Watchdog Factor 2) × 10 ms
11	Min TSDR	Minimum slave TSDR (see Profibus-DP standard)
12-13	PNO_Identifier	Slave identification number (see Profibus-DP standard)
14	Group Flags	Identifiers that characterize the slave's group (see Profibus-DP standard)
15	Address ID	Slave's address on the bus
16	Modular slave	Value = 16#00 / 16#01 if the slave is a compact / modular equipment device
17	Active slave	Value = 16#00 / 16#01 if the slave is inactive/active on the network
18-19	Parameters size	Size (a bytes) of the parameters data block for that slave
20-21	Configuration data size	Size (b bytes) of the configuration data block for that slave
22-23	Size of the data used	Size (c bytes) of the data block used for that slave
24-	Parameters	Parameters data block for that slave
(23+a)
(24+a)-	Configuration data	Configuration data block for that slave
(23+a+b)
(24+a+b)-	Data used	Data block used for that slave
(23+a+b+c)

106