SSI America 9210 user manual Analog Output Setup

M4557 - Model 9210 Nitriding Controller

Use curve

0

Select the “TC Type” option and press the Enter button. This will display a screen with the different input types available. Note: See the Input type selections for the Series 9210 below for the different input types available. The “Filter Time” selection will display a numeric keypad from which the user can enter the new filter time. This can range from 0 to 9999. The “Initial Scale” selection will display a numeric keypad from which the user can enter the new initial scale. This can range from -9999to 9999. The “Full Scale” selection will display a numeric keypad from which the user can enter the new full scale. This can range from –999-to 9999. The “Decimal Point Location” selection will display a numeric keypad from which the user can enter the new decimal point location. This can range from 0 to 4. The “Open TC” selection will display a screen from which the user can enter the new filter time. This can be either Up Scale or Down Scale. The “Input Offset” selection will display a numeric keypad from which the user can enter the new input offset. This can range from -10to 10. The “Use Curve” selection will display a numeric keypad from which the user can enter the new curve to use. This can range from 0 to 5. 0 means no curve is used. Continue until all values associated/required by the input type have been entered. Pressing the Esc key takes you back to the configuration menu.

Input type selections for the Series 9210:

Input Type Options	T/C’s B, C, E, J, K, N, NNM, R, S, T
	2.5 Volts
	1.25 Volts
	78.125 Millivolts
	19.53125 Millivolts
	4 – 20 mA (124 Ohm precision shunt required)
	25 Volts (Requires internal jumper)
	12.5 Volts (Requires internal jumper)
	781.25 Millivolts (Requires internal jumper)
	195.3125 Millivolts (Requires internal jumper)

Analog Output Setup

This menu screen is similar in function to the Analog Input Setup screen, with the exception that these are analog outputs, not inputs. There are two analog output available. The top blue up and down arrow keys highlight either Output 1 or Output 2. The lower blue up and down arrow keys will allow the user to set up the analog output settings.

Parameter	Value
Assignment	PV 2 retrans
Offset	0
Range	100

The “Assignment” selection will display a screen from which the user can select the new assignment. For example you can re-transmit PV1 (Process Variable 1 - %C) to a chart recorder or an analog input board in a PLC. In most Nitrider applications Output 1 is used to control the backpressure and Output 2 is used for Temperature control. The list of options is:

PV 1 retrans

Loop 1 Inc

Loop 1 Dec

Loop 1 Combo

PV 2 retrans

Loop 2 Inc

SSi Manual SERIES 9210-M4557-Nitriding Page 30 of 30