SSI America 9210 Furnace Setup, None BP Back Pressure Temp, Internal Loop Instrument 1 Instrument

M4557 - Model 9210 Nitriding Controller

Furnace Setup

The “Nitrider Mode” selection will allow the user to select the specific Nitriding mode:

H2 and Dissociation

NH3 and Dissociation

H2, NH3 and Dissociation

H2, NH3 and Nit. Potential

H2 and Nit. Potential

NH3 and Nit. Potential

H2 and H2 Control

NH3 and NH3 Control

The “H2 Cell Type” selection will allow the user to set the H2 cell type. It can be either Hi or H2.

The “H2 RS-232 Comms” selection will allow the user to know if there are RS-232 communications. It can be either Yes or No.

The “Temp display” selection will allow the user to set the temperature display source. It can be either Internal or SPP Instrument.

The “LP3 Control” selection allows the user to set the loop 3 control factor:

None

BP (Back Pressure)

N/A

Temp

The “N2 Valve” selection will allow the user to set the N2 valve. It can be either Yes or No. The “NH3 Valve” selection will allow the user to set the NH3 valve. It can be either Yes or No.

The “D.A. Valve” selection will allow the user to set the Dissociated Ammonia valve. It can be either Yes or No.

The “Aux Valve” selection will allow the user to set the auxiliary valve. It can be either Yes or No. The “Temperature Mode” selection will allow the user to set the temperature mode. It can be either °F (Fahrenheit) or °C (Celsius).

The programmer section will allow the user to set up the different instruments for the programmer. The “Atm. Inst” selection will allow the user to set the atmosphere instrument:

Internal Loop 1

Internal Loop 2

Internal Loop 3

Instrument 1 – Instrument 25

The “Temp. Inst” selection will allow the user to set the temperature instrument:

Internal Loop 1

SSi Manual SERIES 9210-M4557-Nitriding Page 26 of 26