Panasonic EY4541 Control Panel, Cutting at the same width, Cutting circles, LED light

Cutting at the same width

1.Place the base onto the workpiece so that the edge of the rip fence and workpiece are put together.

2.Without letting the blade touch the workpiece, turn on the power switch.

3.Face the rip fence firmly to the work- piece to cut parallel line.

Cutting circles

1.If cutting away a section, make a drill hole on workpiece to let the jigsaw blade pass through.

2.Align the pin hole of the rip fence with the center of the circle, and then use a nail or screw to hold the object in place.

3.Without touching the workpiece, turn on the power switch.

4.Cut along the marked line.

Control Panel

(1)

(3)

(2)

(1) LED light

Before the use of LED light, always pull the power switch once.

Press the LED light button.

The light illuminates with very low cur- rent, and it does not adversely affect the performance of the driver during use or its battery capacity.

CAUTION:

•The built-in LED light is designed to il- luminate the small work area tempo- rarily.

•Do not use it as a substitute for a reg- ular flashlight, since it does not have enough brightness.

•LED light turns off when the tool has not been used for 5 minutes.

Caution : DO NOT STARE INTO BEAM. Use of controls or adjustments or perform- ance of procedures other than those spec- ified herein may result in hazardous radia- tion exposure.

- 14 -