Automatic Buttonhole (Continued)
1Guide slot
2 Guide block
3 Buttonhole guide plate
4 Buttonhole template
5 Catch
6 Setting mark
7 Gear
8 Base plate
9 Lever
Select a buttonhole template 4 . Pull back the guide plate catch 5 , and slide the template into the guide plate 3 to get the desired buttonhole. Release the catch to lock the template into place. Insert the gear 7 of the base plate into the template guide slot 1 so that the guide block 2 fits into the center of the guide slot.
1Needle thread
2 Bobbin thread
3 Buttonhole foot
4 Gear
5 Slot
6 Starting point
Attach the buttonhole foot 3 . Adjust the position of the gear 4 , so it is aligned with the starting point of the template 6 . The lever can be used to change gear positions. Pull the bobbin thread up through the guide slot of the buttonhole guide plate by turning the handwheel counterclockwise while holding the needle thread. Place the bobbin and needle threads to the left side of the guide plate. Leave 3" to 4" (7.0 to 10.0 cm) of thread.
3
4
1
5
6
9
2
7
8
5
3
1 | 4 |
6
2
94