• Bobbin winding
1Pull the handwheel out to the right.
2 Draw the thread from the spool.
3 Guide the thread around the thread guide. A For the horizontal spool pin
B For the additional spool pin
4 Thread through the hole in the bobbin from the inside to the outside.
5 Put the bobbin on the bobbin winder spindle.
6 Push the bobbin to the right.
7 With the free end of the thread held in your hand, depress the foot control. Stop the machine when it has made a few turns, and then cut the thread close to the hole in the bobbin.
8 Depress the foot control again. When the bobbin is fully wound, it stops automatically. Return the bobbin winder to its original position by moving the spindle to the left, and cut the thread as shown.
9Push the handwheel in. The machine will not sew until the clutch is engaged.
NOTE:
The position of the bobbin winder stopper is adjustable depending on the required amount of thread on the bobbin (example: 1/2 full or full). Using a screwdriver, loosen the screw one turn or less, so that you can adjust the position of the bobbin winder stopper. Do not take the screw all the way out. Retighten the screw to fix the stopper at the desired position.
3
4 
5
8
3 
A
2
4
1
9
B
3
6 
7
24