Aiwa XR-M88 manual Specifications

Page 22

SPECIFICATIONS

STEREO RECEIVER RX-LM88

SPEAKER SYSTEM SX-LM200

Cabinet type

2 way, bass reflex (magnetic

 

shielded type)

Speakers

Woofer:

 

100 mm cone type

FM tuner section

Tuning range

Usable sensitivity (IHF) Antenna terminals

AM tuner section

Tuning range

Usable sensitivity

Antenna

Amplifier section

Power output

Total harmonic distortion

outputs

General

Power requirements Power consumption Standby power consumption

Dimensions (W x H x D)

Weight

87.5MHz to 108 MHz

13.2dBf

75 ohms (unbalanced)

530 kHz to 1710 kHz (1OkHz step)

531 kHz to 1602 kHz (9 kHz step)

350pV/m Loop antenna

16 watts per channel

RMS at 6 ohms, from 65 Hz to 15 kHz, with no more than 1 % Total Harmonic Distortion

0.1% (7 W, 1 kHz, 6 ohms, DIN AUDIO)

SUPER WOOFER: 1.4V

SPEAKERS: accept speakers of 6 ohms or more

PHONES (stereo mini jack): accepts headphones of 32 ohms or more

120 V AC, 60 HZ

50 w

2.5W (power economizing mode set to ON)

144 x 100 x 206.5 mm (53/, x 4 x 8’/, in.)

2.7kg (5 Ibs 15 OZ)

 

Tweeter:

 

 

25 mm balanced dome type

Impedance

6 ohms

 

Output sound pressure level

87 dEUWlm

 

Dimensions (W x H x D)

120x

200x

182mm

 

(43/4 x

77/8X

7’7/4 h,)

Weight

1.6 kg (3 Ibs 8 02)

Specifications and external appearance are subject to change without notice.

LWESYSTEM

The word “BBE and the “BBEsymbol” are trademarks of BBE Sound, Inc.

Under license from BBE sound, Inc.

COPYRIGHT

Please check the laws on copyright relating to recordings from discs, radio or external tape for the country in which the machine is being used.

NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to prowde reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used m accordance with the

instructions, may cause harmful interference to radio communlcabons. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which

STEREO CASSETTE DECWCOMPACTDISC PLAYER FD-LM88

Compact disc player section

 

Laser

Semiconductor laser (k= 780 nm)

D-A converter

1 bit dual

Signal-to-noise ratio

85 dB (1 kHz, OdB)

Harmonic distortion

0.05 % (1 kHz, OdB)

Wow and flutter

Unmeasurable

Cassette deck section

 

Track format

4 tracks, 2 channels stereo

Frequency response

CrO, tape: 50 Hz – 16000 Hz

 

Normal tape: 50 Hz – 15000 Hz

Signal-to-noise ratio

54 dB (CrOztape peak level)

Recording system

AC bias

Heads

Recording/playback head xl

 

Erase head x2

General

 

Inputs

MD IN: 470 mV

 

AUX IN: 400 mV

outputs

DIGITAL OUT

 

LINE OUT 400 mV

Dimensions (W x H x D)

144 x 100.6 x 203 mm

 

(53/4x 4 x 8 in.)

Weight

1.5 kg (3 Ibs 15 02)

can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

–Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver. –Connect the equipment into an outlet on circuit different from

that to which the receiver is connected.

–Consult the dealer or an experienced radioiTV technician for help.

CAUTION

Modifications or adjustments to this product, which are not expressly approved by the manufacturer, may void the user’s right or authority to operate this product.

22 ENGLISH

Image 22
Contents Clumo ANTENN,4’LEAOINWIRE PrecautionsAC power cord Outdoor AntennaTable of Contents Connect the speaker cords to the speakers Before connecting the AC cordConnections Connect the speaker cords to the tuner/amplifierConcerning the Display WINDOW’S Demo Display Connecting AN Outdoor AntennaPlacing the TWO Units Side by Side To use the Function button on the CD/tape unit Using the Remote ControlBefore Operation Opening and closing the top coverEconomizing Power Setting the ClockDimming the Display Adjusting the Sound ‘@GiiJ’EEiiiiPManual Tuning Press the + or button to select a stationPreset Number Tuning Presetting StationsRepeat steps 1 Playing a Disc OperationLoading a Disc Load a disc with the label side upRandom Play Programmed PlayRepeat Play Loading a Tape To select a reverse modeTo start play when the power is off Direct Play Function Playing Back a TapeAbout cassette tapes Load the tape to be recorded on into the deck Basic RecordingInserting Blank Spaces Press the REC button on the CD/tape unit to start recordingLoad the tape into the cassette deck Al Edit RecordingPress the numbered buttons to designate the tape length To clear the edit programTo change the program of each side Programmed Edit RecordingRepeat for the rest of the tracks for side a To clear the edit programPrepare the source and recording destination Timer Play and Timer RecordingOff timer standby mode Press the II buttonSetting the Sleep Timer Using the system while the timer is setAUX in Jacks Connecting Optional EquipmentMD in Jacks Line OUT JacksCare of CDs Care and MaintenanceListening to External Sources Play the corresponding equipment connectedSpecifications Tuner Section Troubleshooting GuideCD Player Section Parts Index NamePage Advertencia PrecaucionesExplication de Ios simbolos graficos Indice Registro del propietarioAntes de conectar el cable electrico de CA ConexionesImportante Colocacion DE DOS Aparatos Lado a Lado Sobre LA Indication DE Demostracion EN LA PantallaConexion DE UNA Antena Exterior De baterias Antes DE LA OperacionMando Distancia Cuando cambiar Ias bateriasReduccion DEL Brillo DE LA Pantalla Ajuste DEL RelojAhorro DE ENERGiA Pulse el botonAjuste DEL Sonido Sintonizacion Manual Pulse el boton ++ o * para seleccionar una emisoraSintonizacion POR Numero DE Presintona Presintonizacion DE EmisorasIll Repita Ios pasos 1 yCarga DE UN Disco OperacionReproduction DE UN Disco Reproduction Repetida Reproduction AleatoriaReproduction Programada Para seleccionar el modo de inversion Reproduction DE UNA CintaPara volver el contador de cinta al +’ ‘ 1‘ Sobre Ias cintas de caseteColocacion DE Espacios EN Blanco Grabacion BasicaCargue la cinta a grabar en la platina Para parar la grabacion Grabacion CON Edicion DE AlCargue la cinta en la piatina Para borrar el programa de editionCargue la cinta en la platina Grabacion CON Edicion ProgramadaRepita el paso 5 para el resto de Ias pistas del Iado a Pulse Ias teclas numeradas para programar una pistaPrepare la fuente y el destino donde se graba Reproduction CON Temporizador Y GrabacionWER Shift Para verificar la hors y fuente especificadas Para cancelar el temporizador de apagadoAjuste DEL Temporizador DE Apagado Para cambiar el ajuste del temporizadorTomas MD Conexion DE UN Equipo OpcionalTomas Line OUT Tomas AUXCuidado Y Mantenimiento Escuchandofuentes ExternasReproduzca el correspond iente equipo conectado Especificaciones Seccion DEL Sintonizador Solucion a Pequenos ProblemasGeneral Seccion DEL Reproductor DE Discos CompactosNdice DE L05 c0MP0NENTE5 Page ~FRAN~AIS ~ InstallationExplication des symboles graphiques AvertissementDES Matieres Raccordez Ies cordons d’enceinte aux enceintes RaccordementsAvant de raccorder Ie cordon secteur Raccordez Ies cordons d’enceinte au tuner/ amplificateurRaccordement D’UNE Antenne Exterieure Installation DES Deux Appareils Cote a CoteAffichage Demo DE L’AFFICHEUR Raccordez Ies antennes fourniesAvant DE LA TelecommandeEmploi Economie D’ENERGIE REGLAGEDEL’HORLOGEAssombrissement DE ’AFFICHEUR Ajustement DU SON ‘\.,..,Q,,,/~Accord Manuel Appuyez sur la touche + ou * pour selectionner une stationRepetez Ies etapes 1 et Prereglage DES StationsAccord PAR Numero DE Prereglage Accord avec Ie numero de prereglageChargement D’UN Disque ExploitationLecture D’UN Disque Lecture Repetee Lecture AleatoireLecture Programmed Chargement D’UNE Cassette Function ModeSelection d’un mode d’inversion Pour avancer ou reculer rapidement, appuyez sur la touchePropos des cassettes FRAN~AISInsertion D’ESPACES Vierges Chargez la cassette a enregistrer clans la platinePlatine I ‘ ‘%-0 Enregistrement D’EDITION AlInserez la cassette clans la platine Pour arreter I’enregistrement Enregistrement D’fDITIONProgrammed Pour modifier Ie programme de chaque facePreparez la source et la destination d’enregistrement Lecture TEMPORIStE ETEnregistrement Temporise Pour ecouter un CD, appuyez sur la touche CD sur laPour verifier Ie temps restant avant la mise hors Tension Reglage DE LA Minuterie ’EXTINCTIONUtilisation de la chahe quand la minuterie est reglee Pour annuler la minuterie d’extinctionGOuiPEMENT EN Option Raccordement D’UN@ljl Exterieures Entretien ET MaintenanceKcOUTE DE sOuRcEs Lisez sur I’equipement correspondent raccordeSysteme D’ENCEINTES SX-LM200 Recepteur Stereo RX-LM88Platine Cassette /LECTEUR DE Disque Compact Stereo FD-LM88 Droits D’AUTEURGuide DE Depannage Pour reinitialiserNomenclature Page Page Page ~// ~0// fh??l-800-BUY-A/ WA. United States and Puerto Rico