Aiwa XR-M88 manual Troubleshooting Guide, Tuner Section, CD Player Section

Page 23

TROUBLESHOOTING GUIDE

If the system fails to perform as described in these Operating Instructions, check the following guide.

GENERAL

There is no sound.

●Is the AC cord connected properly?

●Is there a bad connection? (+ page 4)

●Was an incorrect function button pressed?

Sound is emitted from one speaker only.

●Is the other speaker disconnected?

Sound becomes inaudible suddenly.

+The protection circuit was activated due to an internal heat build-up. Turn off the power, make sure there is sufficient clearance behind the ventilation openings on the rear, and

leave the system until it cools down.

An erroneous display or a malfunction occurs, or an error message appears.

+Reset the system as stated below.

TUNER SECTION

There is constant, wave-like static.

. Is the antenna connected properly? (+ page 5)

●Is the signal weak?

+ Connect an outdoor antenna.

The reception contains noise interferences or the sound is distorted.

●Is the system picking up external noise or multipath distortion?

+Change the orientation of the antenna.

+Move the system away from other electrical appliances.

CD PLAYER SECTION

The CD player does not play.

●Is the disc correctly inserted? (+ page 11)

●Is the disc dirty? (+ page 21)

●Is the lens affected by condensation?

+ Wait approximately one hour and try again.

To reset

If an unusual condition occurs in the display window, reset the system as follows.

1Press the POWER button to turn off the power.

2Press the POWER button to turn the power back on while

pressing the ■ button. Everything stored in memory after purchase is canceled.

If the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord and repeat step 2.

CASSETTE DECK SECTION

The tape does not run.

●Is the deck in pause mode? (+ page 13)

The sound is off-balance or not adequately high.

●Is the playback head dirty? (+ page 21)

Recording is not possible.

●Is the erasure prevention tab on the tape broken off? (+ page14)

●Is the recording head dirty? (+ page 21)

Erasure is not possible.

●Is the erasure head dirty? (+ page 21)

●Is a metal tape being used?

High frequency sound is not emitted.

● Is the recording/playback head dirty? (+ page 21)

ENGLISH 23

Image 23

Contents Clumo Outdoor Antenna PrecautionsAC power cord ANTENN,4’LEAOINWIRETable of Contents Connect the speaker cords to the tuner/amplifier Before connecting the AC cordConnections Connect the speaker cords to the speakersPlacing the TWO Units Side by Side Connecting AN Outdoor AntennaConcerning the Display WINDOW’S Demo Display Opening and closing the top cover Using the Remote ControlBefore Operation To use the Function button on the CD/tape unitDimming the Display Setting the ClockEconomizing Power ‘@GiiJ’EEiiiiP Adjusting the SoundPress the + or button to select a station Manual TuningRepeat steps 1 Presetting StationsPreset Number Tuning Load a disc with the label side up OperationLoading a Disc Playing a DiscRepeat Play Programmed PlayRandom Play Playing Back a Tape To select a reverse modeTo start play when the power is off Direct Play Function Loading a TapeAbout cassette tapes Press the REC button on the CD/tape unit to start recording Basic RecordingInserting Blank Spaces Load the tape to be recorded on into the deckTo clear the edit program Al Edit RecordingPress the numbered buttons to designate the tape length Load the tape into the cassette deckTo clear the edit program Programmed Edit RecordingRepeat for the rest of the tracks for side a To change the program of each sidePress the II button Timer Play and Timer RecordingOff timer standby mode Prepare the source and recording destinationUsing the system while the timer is set Setting the Sleep TimerLine OUT Jacks Connecting Optional EquipmentMD in Jacks AUX in JacksPlay the corresponding equipment connected Care and MaintenanceListening to External Sources Care of CDsSpecifications CD Player Section Troubleshooting GuideTuner Section Name Parts IndexPage Explication de Ios simbolos graficos PrecaucionesAdvertencia Registro del propietario IndiceImportante ConexionesAntes de conectar el cable electrico de CA Conexion DE UNA Antena Exterior Sobre LA Indication DE Demostracion EN LA PantallaColocacion DE DOS Aparatos Lado a Lado Cuando cambiar Ias baterias Antes DE LA OperacionMando Distancia De bateriasPulse el boton Ajuste DEL RelojAhorro DE ENERGiA Reduccion DEL Brillo DE LA PantallaAjuste DEL Sonido Pulse el boton ++ o * para seleccionar una emisora Sintonizacion ManualRepita Ios pasos 1 y Presintonizacion DE EmisorasIll Sintonizacion POR Numero DE PresintonaReproduction DE UN Disco OperacionCarga DE UN Disco Reproduction Programada Reproduction AleatoriaReproduction Repetida Para volver el contador de cinta al Reproduction DE UNA CintaPara seleccionar el modo de inversion Sobre Ias cintas de casete +’ ‘ 1‘Cargue la cinta a grabar en la platina Grabacion BasicaColocacion DE Espacios EN Blanco Para borrar el programa de edition Grabacion CON Edicion DE AlCargue la cinta en la piatina Para parar la grabacionPulse Ias teclas numeradas para programar una pista Grabacion CON Edicion ProgramadaRepita el paso 5 para el resto de Ias pistas del Iado a Cargue la cinta en la platinaWER Shift Reproduction CON Temporizador Y GrabacionPrepare la fuente y el destino donde se graba Para cambiar el ajuste del temporizador Para cancelar el temporizador de apagadoAjuste DEL Temporizador DE Apagado Para verificar la hors y fuente especificadasTomas AUX Conexion DE UN Equipo OpcionalTomas Line OUT Tomas MDReproduzca el correspond iente equipo conectado Escuchandofuentes ExternasCuidado Y Mantenimiento Especificaciones Seccion DEL Reproductor DE Discos Compactos Solucion a Pequenos ProblemasGeneral Seccion DEL SintonizadorNdice DE L05 c0MP0NENTE5 Page Avertissement InstallationExplication des symboles graphiques ~FRAN~AIS ~DES Matieres Raccordez Ies cordons d’enceinte au tuner/ amplificateur RaccordementsAvant de raccorder Ie cordon secteur Raccordez Ies cordons d’enceinte aux enceintesRaccordez Ies antennes fournies Installation DES Deux Appareils Cote a CoteAffichage Demo DE L’AFFICHEUR Raccordement D’UNE Antenne ExterieureEmploi DE LA TelecommandeAvant Assombrissement DE ’AFFICHEUR REGLAGEDEL’HORLOGEEconomie D’ENERGIE ‘\.,..,Q,,,/~ Ajustement DU SONAppuyez sur la touche + ou * pour selectionner une station Accord ManuelAccord avec Ie numero de prereglage Prereglage DES StationsAccord PAR Numero DE Prereglage Repetez Ies etapes 1 etLecture D’UN Disque ExploitationChargement D’UN Disque Lecture Programmed Lecture AleatoireLecture Repetee Pour avancer ou reculer rapidement, appuyez sur la touche Function ModeSelection d’un mode d’inversion Chargement D’UNE CassetteFRAN~AIS Propos des cassettesChargez la cassette a enregistrer clans la platine Insertion D’ESPACES ViergesInserez la cassette clans la platine Enregistrement D’EDITION AlPlatine I ‘ ‘%-0 Pour modifier Ie programme de chaque face Enregistrement D’fDITIONProgrammed Pour arreter I’enregistrementPour ecouter un CD, appuyez sur la touche CD sur la Lecture TEMPORIStE ETEnregistrement Temporise Preparez la source et la destination d’enregistrementPour annuler la minuterie d’extinction Reglage DE LA Minuterie ’EXTINCTIONUtilisation de la chahe quand la minuterie est reglee Pour verifier Ie temps restant avant la mise hors Tension@ljl Raccordement D’UNGOuiPEMENT EN Option Lisez sur I’equipement correspondent raccorde Entretien ET MaintenanceKcOUTE DE sOuRcEs ExterieuresDroits D’AUTEUR Recepteur Stereo RX-LM88Platine Cassette /LECTEUR DE Disque Compact Stereo FD-LM88 Systeme D’ENCEINTES SX-LM200Pour reinitialiser Guide DE DepannageNomenclature Page Page Page ~// ~0// fh??l-800-BUY-A/ WA. United States and Puerto Rico