BASIC RECORDING
9
II
●REC
CD
FUNCTION
TUNER/
BAND
t
|
| a |
| |
|
| 0 |
| |
Cassette | \u | 1 |
| |
● |
| |||
deck | $ |
| $ |
|
|
|
| ||
| c1 |
|
| *I |
| Q | SHIFT I II ■ | ||
| ● RECI | TAPE | ||
|
|
| ||
REC MUTE
Preparation
●Set the ta~e to the ~oint where recording will start.
●Use Type I (normal) and Type II (high/C
1Load the tape to be recorded on into the deck.
Load the tape with the side to be recorded on first facing upward and the exposed side facing to the right.
I | r- 1 |
0
~
To stop recording, press the g button. When recording from a CD, press the ■ button again to stop playback.
To pause recording, press the II button. (Applicable when recording from a radio broadcast or connected equipment.) To resume recording, press again.
INSERTING BLANK SPACES
Insertion of
1Press the ● REC/REC MUTE button on the remote control during recording or while in recording pause mode.
“TAPE ~“ flashes rapidly for 4 seconds and the tape runs without recording. After 4 seconds, the deck enters the recording pause mode.
2Press the 1I button to resume recording.
To insert a blank space of less than 4 seconds, press the ● REC/REC MUTE button again while “TAPE~“ is flashing rapidly.
To insert blank spaces of more than 4 seconds, after the deck enters recording pause mode, press the ● REC/REC MUTE button again. Each time the button is pressed, a
2 Press the TAPE button on the remote control to select the reverse mode.
To record on one side only, select Z.
To record on both sides, select 1) or (=1.
When recording is started from the side facing downward, the tape stops at the end of recording of this side, even if the reverse mode is set to =) or C=).
3 Press one of the function buttons and prepare the source to be recorded.
To record from a radio broadcast, press the TUNER/BAND button on the remote control and tune in to a station.
To record from a CD, press the CD button on the remote control and load a CD.
To record from equipment connected to the AUX IN jacks or the MD IN jacks, press the AUX/MD button repeatedly to display “AUXor “MDrespectively, and prepare the equipment for playback.
4 Press the ● REC button on the CD/tape unit to start recording.
To start recording with the remote control, press the ● REC/ REC MUTE button and within 2 seconds, press the > button. When recording from a CD, playback and recording start simultaneously.
When recording from connected equipment, start playback.
To erase a recording
1Load the tape to be erased into the deck.
2Set the tape to the point where the erasure is to be started.
3Press the AUX/MD button on the remote control, or press repeatedly the FUNCTION button on the CD/tape unit so that “AUX is displayed.
If an optional equipment is connected to the AU)( IN jacks, turn it off.
4Press the ● REC button on the CD/tape unit to start the erasure.
ENGLISH 15