INSTALLING THE DUAL 56K LAN

4 MODEM

This chapter explains how to connect your computer to the Dual 56K LAN Modem and install the cables in preparation for configuring the unit.

When you first set up the LAN Modem, you initially connect only one computer to the unit. After you have finished configuring the LAN Modem from that computer using a standard web browser, you can then begin to network additional computers, hubs, and/or printers to the LAN Modem.

Before You Start the Before you install the Dual 56K LAN Modem, have the following items ready.

Installation

Two analog (RJ-11 to RJ-11) telephone cables (provided).

One 10BASE-T Ethernet cable (RJ-45 to RJ-45). It is recommended that you use the cable provided. If, however, you choose to use another cable, it must be a straight-through, 10BASE-T Ethernet cable. A crossover cable cannot be used to connect the LAN Modem to your computer.

Power adapter (you must use the power adapter provided in the package).

Installation Steps To install the Dual 56K LAN Modem:

1Turn off your computer.

2Connect your computer to any LAN port (if you are unsure, use Port 1), using the Ethernet cable provided, as shown in Figure 25.

 

2

1

4

 

3LAN

RJ-45

 

 

 

 

 

 

 

 

 

 

 

E 2

 

 

 

 

 

 

 

 

 

PH

O

N

 

 

 

 

 

 

 

E

2

 

 

 

 

 

 

 

 

LIN

 

 

 

 

 

 

 

 

1

 

 

 

 

 

 

 

ON

E

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

E

1

PH

 

 

 

 

 

 

 

 

LIN

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Ethernet

cable

RJ-45

Figure 25 Ethernet Cable Connection

3Connect the two analog cables to the ports labeled LINE 1 and LINE 2 on the Dual 56K LAN Modem’s back panel, and insert the opposite ends into two available analog wall jacks, as shown in Figure 26.

If you are only using one line, use the LINE 1port.

Page 43
Image 43
3Com manual Installing the Dual 56K LAN Modem, Installation