Accton Technology ES3526XA, ES3552XA manual Configuring 802.1X Port Authentication

RADIUS server

1. Client attempts to access a switch port.

2. Switch sends client an identity request.

3. Client sends back identity information.

4. Switch forwards this to authentication server.

5. Authentication server challenges client.

6. Client responds with proper credentials.

7. Authentication server approves access.

8. Switch grants client access to this port.

802.1x client

3 Configuring the Switch

Configuring 802.1X Port Authentication

Network switches can provide open and easy access to network resources by simply attaching a client PC. Although this automatic configuration and access is a desirable feature, it also allows unauthorized personnel to easily intrude and possibly gain access to sensitive network data.

The IEEE 802.1X (dot1X) standard defines a port-based access control procedure that prevents unauthorized access to a network by requiring users to first submit credentials for authentication. Access to all switch ports in a network can be centrally controlled from a server, which means that authorized users can use the same credentials for authentication from any point within the network.

This switch uses the Extensible Authentication Protocol over LANs (EAPOL) to exchange authentication

protocol messages with the client, and a remote RADIUS authentication server to verify

user identity and access rights. When a client

(i.e., Supplicant) connects to a switch port, the switch

(i.e., Authenticator) responds with an EAPOL identity request. The client provides its identity (such as a user name) in an EAPOL response to the switch, which it forwards to the RADIUS server. The RADIUS server verifies the client identity and sends an access challenge back to the client. The EAP packet from the RADIUS server contains not only the challenge, but the authentication method to be used. The client can reject the authentication method and request another, depending on the configuration of the client software and the RADIUS server. The encryption method used to pass authentication messages can be MD5 (Message-Digest 5), TLS (Transport Layer Security), TTLS (Tunneled Transport Layer Security), or PEAP (Protected Extensible Authentication Protocol). The client responds to the appropriate method with its credentials, such as a password or certificate. The RADIUS server verifies the client credentials and responds with an accept or reject packet. If authentication is successful, the switch allows the client to access the network. Otherwise, network access is denied and the port remains blocked.

The operation of 802.1X on the switch requires the following:

•The switch must have an IP address assigned.

•RADIUS authentication must be enabled on the switch and the IP address of the RADIUS server specified.

•802.1X must be enabled globally for the switch.

•Each switch port that will be used must be set to dot1X “Auto” mode.

•Each client that needs to be authenticated must have dot1X client software installed and properly configured.

3-68