Accton Technology ES3526XA, ES3552XA manual Resetting the System

3 Configuring the Switch

CLI – Enter the IP address of at least one SMTP server, set the syslog severity level to trigger an email message, and specify the switch (source) and up to five recipient (destination) email addresses. Enable SMTP with the logging sendmail command to complete the configuration. Use the show logging sendmail command to display the current SMTP configuration.

Console(config)#logging sendmail host 192.168.1.200			4-50
Console(config)#logging sendmail level 4			4-51
Console(config)#logging sendmail source-email john@acme.com			4-52
Console(config)##logging sendmail destination-email geoff@acme.com			4-52
Console(config)#logging sendmail			4-53
Console(config)#exit
Console#show logging sendmail			4-53
SMTP	servers
-----------------------------------------------
1.	192.168.1.200
SMTP	minimum severity level: 4
SMTP	destination email addresses
-----------------------------------------------
1.	geoff@acme.com
SMTP	source email address:	john@acme.com
SMTP	status:	Enabled

Console#

Resetting the System

Web – Click System, Reset to reboot the switch. When prompted, confirm that you want reset the switch.

Figure 3-20 Resetting the System

CLI – Use the reload command to restart the switch. When prompted, confirm that you want to reset the switch.

Console#reload	4-23
System will be	restarted, continue <y/n>? y

Note: When restarting the system, it will always run the Power-On Self-Test.

3-34