Accton Technology ES3526XA, ES3552XA manual Configuring Interface Settings

3 Configuring the Switch

CLI – This example shows the STA attributes for port 5.

Console#show spanning-tree	ethernet 1/5	4-176
Eth 1/ 5 information
--------------------------------------------------------------
Admin status:	enabled
Role:	disable
State:	discarding
External admin path cost:	10000
Internal admin cost:	10000
External oper path cost:	10000
Internal oper path cost:	10000
Priority:	128
Designated cost:	10000
Designated port:	128.1
Designated root:	32768.0.0000E8AAAA00
Designated bridge:	32768.0.0030F1D473A0
Fast forwarding:	disabled
Forward transitions:	2
Admin edge port:	disabled
Oper edge port:	disabled
Admin Link type:	auto
Oper Link type:	point-to-point
Spanning Tree Status:	enabled

Console#

Configuring Interface Settings

You can configure RSTP and MSTP attributes for specific interfaces, including port priority, path cost, link type, and edge port. You may use a different priority or path cost for ports of the same media type to indicate the preferred path, link type to indicate a point-to-point connection or shared-media connection, and edge port to indicate if the attached device can support fast forwarding. (References to “ports” in this section means “interfaces,” which includes both ports and trunks.)

Command Attributes

The following attributes are read-only and cannot be changed:

•STA State – Displays current state of this port within the Spanning Tree. (See Displaying Interface Settings on page 3-127for additional information.)

•Discarding - Port receives STA configuration messages, but does not forward packets.

•Learning - Port has transmitted configuration messages for an interval set by the Forward Delay parameter without receiving contradictory information. Port address table is cleared, and the port begins learning addresses.

•Forwarding - Port forwards packets, and continues learning addresses.

•Trunk11 – Indicates if a port is a member of a trunk.

11. STA Port Configuration only

3-130