Accton Technology ES3552XA Interface Commands Function Mode, Port-channel channel-idRange

Interface Commands 4

Interface Commands

These commands are used to display or set communication parameters for an Ethernet port, aggregated link, or VLAN.

Table 4-45 Interface Commands

Command	Function	Mode	Page
interface	Configures an interface type and enters interface configuration	GC	4-131
	mode
description	Adds a description to an interface configuration	IC	4-132
speed-duplex	Configures the speed and duplex operation of a given interface	IC	4-132
	when autonegotiation is disabled
negotiation	Enables autonegotiation of a given interface	IC	4-133
capabilities	Advertises the capabilities of a given interface for use in	IC	4-134
	autonegotiation
flowcontrol	Enables flow control on a given interface	IC	4-135
shutdown	Disables an interface	IC	4-136
switchport broadcast	Configures the broadcast storm control threshold	IC	4-137
packet-rate
clear counters	Clears statistics on an interface	PE	4-137
show interfaces status	Displays status for the specified interface	NE, PE	4-138
show interfaces	Displays statistics for the specified interfaces	NE, PE	4-139
counters
show interfaces	Displays the administrative and operational status of an	NE, PE	4-140
switchport	interface

interface

This command configures an interface type and enter interface configuration mode. Use the no form to remove a trunk.

Syntax

interface interface

no interface port-channel channel-id

interface

•ethernet unit/port

-unit - This is unit 1.

-port - Port number. (Range: 1-26/52)

•port-channel channel-id(Range: 1-4)

•vlan vlan-id(Range: 1-4094)

Default Setting

None

4-131