3 Configuring the Switch

other STA-related timeout problems. However, remember that Edge Port should only be enabled for ports connected to an end-node device. (Default: Disabled)

Migration – If at any time the switch detects STP BPDUs, including Configuration or Topology Change Notification BPDUs, it will automatically set the selected interface to forced STP-compatible mode. However, you can also use the Protocol Migration button to manually re-check the appropriate BPDU format (RSTP or STP-compatible) to send on the selected interfaces. (Default: Disabled)

Web – Click Spanning Tree, STA, Port Configuration or Trunk Configuration. Modify the required attributes, then click Apply.

Figure 3-72 STA Port Configuration

CLI – This example sets STA attributes for port 7.

Console(config)#interface ethernet 1/7

4-131

Console(config-if)#no spanning-tree spanning-disabled

4-170

Console(config-if)#spanning-tree port-priority 0

4-171

Console(config-if)#spanning-tree cost 50

4-170

Console(config-if)#spanning-tree link-type auto

4-173

Console(config-if)#no spanning-tree edge-port

4-172

Console(config-if)#spanning-tree protocol-migration

4-176

 

 

Configuring Multiple Spanning Trees

MSTP generates a unique spanning tree for each instance. This provides multiple pathways across the network, thereby balancing the traffic load, preventing wide-scale disruption when a bridge node in a single instance fails, and allowing for faster convergence of a new topology for the failed instance.

By default all VLANs are assigned to the Internal Spanning Tree (MST Instance 0) that connects all bridges and LANs within the MST region. This switch supports up to 33 instances. You should try to group VLANs which cover the same general area of your network. However, remember that you must configure all bridges within the same MSTI Region (page 3-125) with the same set of instances, and the same instance (on each bridge) with the same set of VLANs. Also, note that RSTP treats each MSTI region as a single node, connecting all regions to the Common Spanning Tree.

3-132

Page 176
Image 176
Accton Technology ES3526XA, ES3552XA Configuring Multiple Spanning Trees, CLI This example sets STA attributes for port