Accton Technology ES3552XA, ES3526XA manual Ip address, IP Interface Commands Function Mode

IP Interface Commands 4

IP Interface Commands

An IP addresses may be used for management access to the switch over your network. The IP address for this switch is obtained via DHCP by default. You can manually configure a specific IP address, or direct the device to obtain an address from a BOOTP or DHCP server when it is powered on. You may also need to a establish a default gateway between this device and management stations or other devices that exist on another network segment.

Table 4-80 IP Interface Commands

Command	Function	Mode	Page
ip address	Sets the IP address for the current interface	IC	4-243
ip default-gateway	Defines the default gateway through which this switch can reach	GC	4-244
	other subnetworks
ip dhcp restart	Submits a BOOTP or DHCP client request	PE	4-245
ip dhcp relay information	Enables or disables DHCP Option 82 information relay	GC	4-240
option
ip dhcp relay information	Sets the information option policy for DHCP client packets that	GC	4-241
policy	include Option 82 information
ip dhcp relay server	Specifies the IP addresses of DHCP servers to be used by the
	switch’s DHCP relay agent
show ip interface	Displays the IP settings for this device	PE	4-245
show ip redirects	Displays the default gateway configured for this device	PE	4-246
ping	Sends ICMP echo request packets to another node on the	NE,	4-246
	network	PE

ip address

This command sets the IP address for the currently selected VLAN interface. Use the no form to restore the default IP address.

Syntax

ip address {ip-address netmask bootp dhcp} no ip address

•ip-address- IP address

•netmask - Network mask for the associated IP subnet. This mask identifies the host address bits used for routing to specific subnets.

•bootp - Obtains IP address from BOOTP.

•dhcp - Obtains IP address from DHCP.

Default Setting

DHCP

Command Mode

Interface Configuration (VLAN)

4-243