Accton Technology ES3552XA, ES3526XA Syntax Show garp timer interface, Shows all Garp timers

GVRP and Bridge Extension Commands 4

Command Usage

•Group Address Registration Protocol is used by GVRP and GMRP to register or deregister client attributes for client services within a bridged LAN. The default values for the GARP timers are independent of the media access method or data rate. These values should not be changed unless you are experiencing difficulties with GMRP or GVRP registration/deregistration.

•Timer values are applied to GVRP for all the ports on all VLANs.

•Timer values must meet the following restrictions:

-leave >= (2 x join)

-leaveall > leave

Note: Set GVRP timers on all Layer 2 devices connected in the same network to

the same values. Otherwise, GVRP may not operate successfully.

Example

Console(config)#interface ethernet 1/1

Console(config-if)#garp timer join 100

Console(config-if)#

Related Commands

show garp timer (4-197)

show garp timer

This command shows the GARP timers for the selected interface.

Syntax

show garp timer [interface]

interface

•ethernet unit/port

-unit - This is unit 1.

-port - Port number. (Range: 1-26/52)

•port-channel channel-id(Range: 1-4)

Default Setting

Shows all GARP timers.

Command Mode

Normal Exec, Privileged Exec

Example

Console#show garp timer ethernet 1/1

Eth 1/ 1 GARP timer status:

Join timer: 100 centiseconds

Leave timer: 60 centiseconds

Leaveall timer: 1000 centiseconds

Console#

4-197