Configuring the Switch
3-96
3
Command Attributes
•Member List (Current) – Shows configured trunks (Unit, Port).
•New – Includes entry fields for creating new trunks.
-Port – Port identifier. (Range: 1-26/52)
Web – Click Port, LACP, Configuration. Select any of the switch ports from the
scroll-down port list and click Add. After you have completed adding ports to the
member list, click Apply.
Figure 3-56 LACP Configuration
CLI – The following example enables LACP for ports 3 to 6. Just connect these ports
to LACP-enabled trunk ports on another switch to form a trunk.
Console(config)#interface ethernet 1/3 4-131
Console(config-if)#lacp 4-148
Console(config-if)#exit
.
.
.
Console(config)#interface ethernet 1/6
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1 4-138
Information of Trunk 1
Basic information:
Port type: 100TX
Mac address: 22-22-22-22-22-2d
Configuration:
Name:
Port admin: Up
Speed-duplex: Auto
Capabilities: 10half, 10full, 100half, 100full
Flow control status: Disabled
Port security: Disabled
Max MAC count: 0
Current status:
Created by: Lacp
Link status: Up
Port operation status: Up
Operation speed-duplex: 100full
Flow control type: None
Member Ports: Eth1/3, Eth1/4, Eth1/5, Eth1/6,
Console#