Set Up the
1If the Operating Mode is set to Standard Mode, proceed to Step 3. Otherwise, press Enter.
2Press Next until the LCD displays STANDARD, then press Enter. The Operating Mode changes to Standard.
3Press Next until HDSL RATE displays, then press Enter.
4Press Next until the desired HDSL transmission rate displays, then press Enter.
To continue setting up the system, proceed to “Configure the
This section continues from Step 4 in “Using the LCD” on page
To set an Extended Mode HDSL Rate, you must:
•Set the Extended Mode Loop Configuration to 1 Loop or 2 Loop, depending on the physical layout of your HDSL network.
•Set the Extended Mode HDSL Rate to one of the options determined by the Extended Mode Loop Configuration:
–1 Loop HDSL Rate settings are between 128 kbps and 1.152 Mbps, in 64 kbps increments.
–2 Loop HDSL Rate settings are between 256 kbps and 2.304 Mbps, in 128 kbps increments.
1With the LCD displaying OPERATING MODE, press the Enter button.
2Press Next until EXTENDED displays, then press Enter. The LCD displays OPERATING MODE.
3Press Next two times. LOOP MODE displays.
4Press Enter.
5Press Next until the desired Loop Mode setting displays, then press Enter. The LCD displays LOOP MODE.