Set Up the Campus-REX System

6Type 8 then press ENTER . A prompt displays, asking you to enter the default router IP address. This address defines the next hop default router for the Campus-REX to use to route packets that have a destination address that is not in the IP Static Routing Table.

7Type the address, in decimal-dotted notation then press ENTER .

8Continue with the following sections.

Entering Port Addresses

This section describes how to enter the port addresses for the Campus unit. There are two port addresses:

•The LAN Port IP address is the IP address for the 10BASE-T port on the Campus-REX.

•The Line Port IP address is the IP address for the HDSL port on the Campus Desktop Unit or Campus-Star chassis. If the HDSL line connects two Campus-REX units, this address is hidden from the rest of the network. In this case, you can assign artificial parameters to the Line Port, although the Line Port addresses must belong to the same IP subnet.

1From the Bridge/Router Configuration menu, type 4 then press ENTER . The terminal prompts you to enter the LAN IP Address.

2Type the address, in decimal-dotted notation, then press ENTER . The new address displays.

3Type 5 then press ENTER . The terminal prompts you to enter the LAN Subnet Mask.

4Type the mask, in decimal-dotted notation, then press ENTER . The new subnet mask displays.

5Type 6 then press ENTER . The terminal prompts you to enter the Line IP Address.

6Type the address, in decimal-dotted notation, then press ENTER . The new address displays.

3-26

Campus-REX RS Interface Card User Manual