Set Up the Campus-REX System

From the LCD

The steps in this section use the menu buttons and LCD on the front of the Desktop Unit or the Campus-Star CMU.

If the Campus-REX has been set as a router, you must use an ASCII terminal if you want to change it back to a bridge. See “From an ASCII Terminal” on page 3-21.

To configure the Bridge options:

1Press Escape until Campus RS I/F: REX displays.

2Press Next twice, until DATA PORT CONFIG & STATUS displays, then press Enter. The LCD displays CONFIGURE REX SETTINGS.

3Press Enter. The LCD displays REX MODE BRIDGE MODE.

4Press Next twice. ENCAPSULATION displays.

5Press Enter. The LCD displays the current Encapsulation setting.

6Press Next until the desired Encapsulation setting displays, then press Enter.

7Press Next. SPANNING TREE displays.

8Press Enter. The LCD displays the current Spanning Tree setting.

9Press Next until the desired Spanning Tree setting displays, then press Enter.

10Press Next. Press Enter to reset interface displays.

11Press Enter. The Campus-REX restarts with the changes in effect.

3-20

Campus-REX RS Interface Card User Manual