Set Up the
To set a Standard HDSL Mode:
1If the HDSL Operating Mode is set to Extended Mode, type 1 then press
ENTER .
2From the HDSL Parameters menu, type 3 then press ENTER . The HDSL Rate option changes to the next setting.
3Repeat the previous step until the HDSL Rate option is set to the desired setting.
4Type R to exit the menu, then confirm any HDSL changes you have made.
To continue setting up the system, proceed to “Configure the
Extended HDSL Mode
This section continues from Step 4 on page
To set a Standard Mode HDSL Rate, you choose from the list of predefined rates. To set an Extended Mode HDSL Rate, you must:
•Set the Extended Mode Loop Configuration to 1 Loop or 2 Loop, depending on the physical layout of your HDSL network.
•Set the Extended Mode HDSL Rate to one of the options determined by the Extended Mode Loop Configuration:
–1 Loop HDSL Rate settings are between 128 kbps and 1.152 Mbps, in 64 kbps increments.
–2 Loop HDSL Rate settings are between 256 kbps and 2.304 Mbps, in 128 kbps increments.