ADC Campus-REX RS Interface Card Setting Up the IP Static Routing Table

Set Up the Campus-REX System

7Type 7 then press ENTER . The terminal prompts you to enter the Line Subnet Mask.

8Type the mask, in decimal-dotted notation, then press ENTER . The new subnet mask displays.

9Continue with the following section.

Setting Up the IP Static Routing Table

This section describes how to enter the IP static routing table for the Campus unit. This table can contain up to four explicit routes and one default router. Each route consists of the destination network, subnet mask, and next-hop gateway. The default route does not have a configurable subnet mask, but uses the mode associated with the LAN or LINE networks, as described in the previous section.

Fill in as many routing table entries as are appropriate to your network. You can also proceed to the next section and leave the IP static routing table blank.

The steps in this section assume that you started from the beginning of the previous section.

1From the Bridge/Router Configuration menu, type 9 then press ENTER . The terminal prompts you to enter the destination address for the first routing table entry.

2Type the destination address, in decimal-dotted notation, then press

ENTER . The terminal prompts you to enter the subnet mask for the table entry.

3Type the mask, in decimal-dotted notation, then press ENTER . The terminal prompts you to enter the gateway address for the table entry.

4Type the gateway address, in decimal-dotted notation, then press ENTER . The terminal displays the Bridge/Router Configuration menu

with the first entry of the routing table filled in.

Campus-REX RS Interface Card User Manual 3-27