Set Up the Campus-REX System

6Press Next. HDSL RATE displays.

7Press Enter.

8Press Next until the desired HDSL transmission rate displays, then press Enter.

To continue setting up the system, proceed to “Configure the Campus-REX as a Bridge or Router” on page 3-19.

AutoSync HDSL Mode

This section continues from Step 4 in “Using the LCD” on page 3-8to set the Extended Mode parameters.

To configure AutoSync Mode, you must:

•Set the Transceiver Mode to Master or Slave.

•If the Transceiver Mode is set to Master, set the HDSL Loop Mode to 1 Loop or 2 Loop, depending on the physical layout of your HDSL network.

•If the Transceiver Mode is set to Master, set the HDSL Rate to one of the options determined by the HDSL Loop Mode:

–1 Loop HDSL Rate settings are between 128 kbps and 1.152 Mbps, in 64 kbps increments.

–2 Loop HDSL Rate settings are between 256 kbps and 2.048 Mbps, in 128 kbps increments.

1With the LCD displaying OPERATING MODE, press Enter.

2Press Next until AUTOSYNC displays, then press Enter.

OPERATING MODE displays. If you are configuring an AutoSync slave system, skip the remainder of this section and proceed to “Configure the Campus-REX as a Bridge or Router” on page 3-19. For an AutoSync master system, continue with the remaining steps.

3Press Next until XCVR MODE displays.

4Press Enter.

5Press Next until the MASTER displays, then press Enter. XCVR MODE displays.

6Press Next until LOOP MODE displays.

3-10

Campus-REX RS Interface Card User Manual