Set Up the
AutoSync HDSL Mode
This section continues from Step 4 on page
To configure AutoSync Mode, you must:
•Set the Transceiver Mode to Master or Slave.
•If the Transceiver Mode is set to Master, set the HDSL Loop Mode to 1 Loop or 2 Loop, depending on the physical layout of your HDSL network.
•If the Transceiver Mode is set to Master, set the HDSL Rate to one of the options determined by the HDSL Loop Mode:
–1 Loop HDSL Rate settings are between 128 kbps and 1.152 Mbps, in 64 kbps increments.
–2 Loop HDSL Rate settings are between 256 kbps and 2.048 Mbps, in 128 kbps increments.
1From the Standard Mode HDSL Parameters menu, type 1 then press ENTER until the HDSL Operating Mode options changes to AutoSync
Mode. If the terminal is already set to the AutoSync Mode HDSL Parameters menu, skip this step.
Dec 9, 1999 | ADC DSL SYSTEMS | INC., CAMPUS RS, Version x.xx | 13:19:32 | ||
Local Unit ID: | Local I/F: | REX | |||
Remote Unit ID: | Remote I/F: REX | ||||
Circuit | ID: | Network Extension Circuit 5001 |
| ||
|
| AUTOSYNC MODE HDSL PARAMETERS |
| ||
1) | HDSL Operating Mode: | Autosync | (Standard, Extended, Autosync) | ||
2) | Transceiver Mode: | Slave | (Master, Slave) |
| |
| HDSL Loop Mode: |
|
|
| |
| HDSL Rate: |
|
|
| |
| Note: |
|
|
| |
| Remote Unit must | be set as Autosync, Master. |
| ||
Changes will not be effective until this menu is exited!
(R)eturn (M)ain Menu
ENTER CHOICE>